V2-EVAL-UK FTDI, V2-EVAL-UK Datasheet - Page 47

• Manufacturer Part Number: V2-EVAL-UK
• Description: BOARD, EVALUATION, UK PSU
• Manufacturer: FTDI

Specifications of V2-EVAL-UK

• Kit Contents: 1 X V2-Eval Base Board, 1x 5V/1A Mains Adapter PSU, 1x USB A/B Cable, 1x USB Gender Changer
• Svhc: No SVHC (18-Jun-2010)
• Kit Features: VNC2 Embedded USB Host / Slave Chip Accessible Via
• Silicon Manufacturer: FTDI
• Silicon Family Name: Vinculum II
• Features: Embedded USB Host / Slave Chip, Two USB Type A Connectors
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

8.2
The V2-EVAL terminal utility is a standard terminal application designed specifically to support the V2-
EVAL board. The application provides communication to the UART interface on the VNC2 device and also
provides commands to control some basic configuration functions on the V2-EVAL board. All
communication and control commands are directed to the V2-EVAL board via the onboard FT4232H USB
to quad channel serial converter.
Figure 8.2: V2-EVAL Terminal Utility Features
The V2-EVAL utility supports standard terminal commands and control functions. Pull down menus list
different UART speeds, and data settings. On the top right hand section of the software a set of check
buttons are available for controlling the V2-EVAL board. A summary of the function of each button on the
V2-EVAL terminal utility is outlined below:
settings - pull
or text format
down menu
Tabs to select
Connection
between hex
Connect
console
button
display
„Connect’ button – Connects and disconnects the terminal utility from the UART hardware.
„Assert RTS’ checkbox – Assert the Request To Send line on the UART interface.
‘Asset DTR’ checkbox – Assert Data Terminal Ready line on the UART interface.
‘UART’ mode button – Enables full UART TX and RX operation through the V2-EVAL terminal
utility. Under the UART mode the select line of the V2-EVAL board multiplexer U4 is set to „0‟
forcing the FT4232H channel A to connect to UART interface on VNC2, as per the conditions
outlined in Table 6.1.
„Spy’ mode button – The „Spy‟ button sets the select line of the V2-EVAL board multiplexer U4 to
„1‟, allowing the VNC2 UART interface to be controlled by an external device connected to the V2-
EVAL board instead of the FT4232H, as per the conditions outlined in Table 6.1. Under this setting
a user can connect to V2-EVAL board in „Spy‟ mode via FT4232H channel C and observe VNC2
UART RX data in the terminal utility. „Spy‟ mode is a read-only UART mode. Any user data input
to the console under this mode is ignored.
‘Assert RESET’ checkbox – When checked the software will enable the RESET# input signal on
the VNC2 device. The checkbox is only available under UART mode.
‘Assert PROG’ checkbox - When checked, the software will enable the PROG# input signal on
the VNC2 device. The checkbox is only available under UART mode.
Using V2-EVAL Terminal
Copyright © 2010 Future Technology Devices International Limited
UART console input and output area
Standard UART terminal control
functions
V2-EVAL Vinculum II Evaluation Board Datasheet Version 2.0
Document Reference No.: FT_000247
V2-EVAL specific board
Clearance No.: FTDI#148
functions
46