ELJRER10JFA Panasonic, ELJRER10JFA Datasheet - Page 15

CHIP INDUCTOR, 100NH, 200mA, 5%, 1300MHZ

ELJRER10JFA

Manufacturer Part Number
ELJRER10JFA
Description
CHIP INDUCTOR, 100NH, 200mA, 5%, 1300MHZ
Manufacturer
Panasonic
Series
REr
Datasheet

Specifications of ELJRER10JFA

Dc Resistance Max
1.8ohm
Dc Current Rating
200mA
Q Factor @ Frequency
12 @ 100MHz
Termination Type
SMD
Self Resonant Frequency
1.3GHz
Test Frequency
100MHz
Lead Free Status / RoHS Status
Lead free / RoHS Compliant

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
ELJRER10JFA
Manufacturer:
PANASONIC
Quantity:
260 000
For securing upgraded reliability and safety, consider following caution items.
1. Land pattern design
2. Mounting
3. Soldering
4. Cleaning
5. Instructions for applying current
6. Storage
Refer to the recommended land dimensions of each type at flow and reflow solderings.
Avoid placing the chip inductor on any metal pattern except the land because the drop of Q and mutual
conductance may occur.
Provisions for venting of flux gases should be made for high density assemblies.
Placement force should not exceed 20N because electric and magnetic characteristics change by applying
strong force.
a Flow soldering
b Reflow soldering
1 Do not use acid or alkari agents. Some cleaning solvents out of CFC may damage the products.
2 If ultrasonic cleaning is employed, please inform us immediately for technical consultation.
The rated current is defined as the smaller value of either the current value when the inductance drops
10 % down from the initial point, or the current value when the average temperature of coil inside rises
20 K up from initial point.
Do not operate this coils beyond the specified rated current.
1 Be careful a high temperature, a large amount of moisture, gases and magnetic field.
2 At long storage of more than 1 year, use the products after inspecting the outer structure
Recommended conditions; 260 ¡C max., 5sec. max.(total time at 2 waves method)
1 Infra-red reflow soldering
2 VPS reflow soldering
Confirm the reliability in advance.
Cautions for use
Recommended conditions: 200 ¡C or high at electrode, 60sec. max. and peak 250 ¡C max., 5sec. max.
If the solder at the two electrodes are not melt simultaneously, the chip inductor may not be mounted
on the right place.
It is recommended to fix by adhesive when the deviation is great.
Recommended conditions: 215±5 ¡C, 20 to 60sec.
Chip Inductors

Related parts for ELJRER10JFA