CYWUSB6935-48LFXI Cypress Semiconductor Corp, CYWUSB6935-48LFXI Datasheet - Page 14

• Manufacturer Part Number: CYWUSB6935-48LFXI
• Description: IC,Upconverter And Downconverter,LLCC,48PIN,PLASTIC
• Manufacturer: Cypress Semiconductor Corp

Specifications of CYWUSB6935-48LFXI

• Frequency: 2.4GHz
• Data Rate - Maximum: 62.5kbps
• Modulation Or Protocol: DSSS, GFSK
• Applications: AMR, ISM, RKE
• Power - Output: 0dBm
• Sensitivity: -95dBm
• Voltage - Supply: 2.7 V ~ 3.6 V
• Current - Receiving: 57.7mA
• Current - Transmitting: 69.1mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 48-VQFN Exposed Pad, 48-HVQFN, 48-SQFN, 48-DHVQFN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 428-1626

Table 15. Transmit SERDES Interrupt Enable
Document #: 38-16008 Rev. *E
7:4 Reserved
Bit
Addr: 0x0D
3
2
1
0
Underflow The Underflow bit is used to enable the interrupt associated with an underflow condition associated with the
Overflow
Done
Empty
7
Name
These bits are reserved and should be written with zeroes.
Transmit SERDES Data register (Reg 0x0F)
1 = Underflow interrupt enabled
0 = Underflow interrupt disabled
An underflow condition occurs when attempting to transmit while the Transmit SERDES Data register (Reg 0x0F)
does not have any data.
The Overflow bit is used to enabled the interrupt associated with an overflow condition with the Transmit SERDES
Data register (0x0F).
1 = Overflow interrupt enabled
0 = Overflow interrupt disabled
An overflow condition occurs when attempting to write new data to the Transmit SERDES Data register (Reg 0x0F)
before the preceding data has been transferred to the transmit shift register.
The Done bit is used to enable the interrupt that signals the end of the transmission of data.
1 = Done interrupt enabled
0 = Done interrupt disabled
The Done condition occurs when the Transmit SERDES Data register (Reg 0x0F) has transmitted all of its data
and there is no more data for it to transmit.
The Empty bit is used to enable the interrupt that signals when the Transmit SERDES register (Reg 0x0F) is empty.
1 = Empty interrupt enabled
0 = Empty interrupt disabled
The Empty condition occurs when the Transmit SERDES Data register (Reg 0x0F) is loaded into the transmit buffer
and it's safe to load the next byte
6
Reserved
5
REG_TX_INT_EN
4
Description
Underflow
3
Overflow
2
Done
1
CYWUSB6935
Default: 0x00
Page 14 of 34
Empty
0
[+] Feedback