NS5-MQ10B-V2 Omron, NS5-MQ10B-V2 Datasheet - Page 130

• Manufacturer Part Number: NS5-MQ10B-V2
• Description: 5 Mono Tchsrn,Serial+USB,Bk 60
• Manufacturer: Omron

Specifications of NS5-MQ10B-V2

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

4-2 1:N Host Connection
4-14
Connecting to CS-series Serial Communications Boards
Serial Communications Boards with RS-232C and RS-422A Ports for Use with CS-series
CPU Units:
Setting DM Area Allocations in CPU Unit
Write the settings directly from the Programming Device or Support Software (Programming
Console or CX-Programmer) to the DM Area (Parameter Area) in the CPU Unit. After writing
the settings, enable the settings by turning ON the power again, restarting the Unit, restart-
ing the communications port, or executing the CHANGE SERIAL PORT SETUP (STUP) in-
struction.
The following table shows the allocated DM Area words and settings.
The allocations and settings are the same for RS-232C and RS-422A (CS1W-SCB41 Port 2).
Note 1. Set the baud rate to a numeric value between 0000 to 0009 Hex. (The setting is the same for
For example, to connect PTs with unit numbers 3 to 6 to Port 1 in 1:N NT Links, set
DM32000 to 8200 Hex, DM32001 to 0000 Hex, and DM32006 to 0006 Hex.
Reference
Allocated DM Area words
DM32000
DM32001
DM32006
Port 1
2. When using a 1:N connection, set the value for @ to 1 or higher.
CS1W-SCB21 (Both ports 1 and 2 are RS-232C ports.)
CS1W-SCB41 (Port 1 is an RS-232C port and Port 2 is an RS-422A port.)
any value between 0000 and 0009 Hex.)
When setting a 1:N NT Link in the CX-Programmer, set the baud rate to 38,400 bps.
DM32010
DM32011
DM32016
Port 2
0000 to 0009
(See note 1.)
Write value
000@
8200
1:N NT Link Mode
Baud rate (normal)
@: Largest unit number (1 to 7) of the con-
nected PTs. (See note 2.)
Settings