NS5-MQ10B-V2 Omron, NS5-MQ10B-V2 Datasheet - Page 74

• Manufacturer Part Number: NS5-MQ10B-V2
• Description: 5 Mono Tchsrn,Serial+USB,Bk 60
• Manufacturer: Omron

Specifications of NS5-MQ10B-V2

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

3-5 Connecting to Printers
3-5-2
3-20
Connecting a PictBridge-compatible Printer
•
Operation checks have been performed for the following printers.
EPSON
(ESC/P raster)
CANON
(BJ raster)
The NS-series PTs with system version 8.1 or higher (except for NS12/10/8/5-V1 and NS5-
@@0@-V2 PTs) support PictBridge-compatible printers. Connect the USB slave connector on
the PT to the printer with a USB cable, as shown in the following figure.
Reference
•
Use a commercially available USB cable (2 m max.).
Manufacturer
Precautions
for Safe Use
Precautions
for Correct Use
Recommended Printers
Connecting Cables
USB slave connector
• Connect the printer directly to the PT with a cable. Connection via a USB hub is not
• When printing with PictBridge, noise may affect the quality of the printout due to proc-
possible.
essing characteristics.
PM-2200C, PM-930C, PM-870C, PM-740C, PM-A970, PM-T990, PM-D870, PM-
G720
PX-5500, PX-A720, PX-G5100, PX-G930
BJ-M70
PIXUS 550i, 50i, 80i, iP2000, iP3100, iP4100, iP4100R, iP90, iP3300
The USB slave connector on an NS-series PT is used to connect both a per-
sonal computer and a PictBridge-compatible printer. (A personal computer is
connected to transfer screen data from the CX-Designer.) Do not try to print
from the PT when the USB slave connector is connected to a personal com-
puter (i.e., do not turn ON $SB25, $SB27, or $SB29 in system bit memory). The
PT or computer may malfunction.
• Printing devices do not have the same general specifications as the PT.
• Do not connect an USB connector to any device that is not applicable.
• Before connecting an USB connector to a device, make sure that the device
• The PT may malfunction if the connecting cable is connected or discon-
Printers may not operate normally in locations subject to noise. When using
a printing device, either install it in a location that is not subject to noise or
provide shielding.
is free of damage.
nected while the power supply to the PT is turned ON. Always turn OFF the
power supply to the printer and PT before connecting or disconnecting the
cable.
PictBridge connector
(USB host connector)
Model