LC4256V-75TN100E LATTICE SEMICONDUCTOR, LC4256V-75TN100E Datasheet - Page 13

• Manufacturer Part Number: LC4256V-75TN100E
• Description: CPLD ispMACH® 4000V Family 256 Macro Cells 168MHz EECMOS Technology 3.3V 100-Pin TQFP
• Manufacturer: LATTICE SEMICONDUCTOR

Specifications of LC4256V-75TN100E

• Package: 100TQFP
• Family Name: ispMACH® 4000V
• Number Of Macro Cells: 256
• Maximum Propagation Delay Time: 7.5 ns
• Number Of User I/os: 64
• Number Of Logic Blocks/elements: 36
• Typical Operating Supply Voltage: 3.3 V
• Maximum Operating Frequency: 168 MHz
• Number Of Product Terms Per Macro: 80
• Memory Type: EEPROM
• Operating Temperature: -40 to 130 °C

Lattice Semiconductor
Figure 10. Global OE Generation for ispMACH 4032
Zero Power/Low Power and Power Management
The ispMACH 4000 family is designed with high speed low power design techniques to offer both high speed and
low power. With an advanced E
approach), the ispMACH 4000 family offers SuperFAST pin-to-pin speeds, while simultaneously delivering low
standby power without needing any “turbo bits” or other power management schemes associated with a traditional
sense-amplifier approach.
The zero power ispMACH 4000Z is based on the 1.8V ispMACH 4000C family. With innovative circuit design
changes, the ispMACH 4000Z family is able to achieve the industry’s “lowest static power”.
IEEE 1149.1-Compliant Boundary Scan Testability
All ispMACH 4000 devices have boundary scan cells and are compliant to the IEEE 1149.1 standard. This allows
functional testing of the circuit board on which the device is mounted through a serial scan path that can access all
critical logic notes. Internal registers are linked internally, allowing test data to be shifted in and loaded directly onto
test nodes, or test node data to be captured and shifted out for verification. In addition, these devices can be linked
into a board-level serial scan path for more board-level testing. The test access port operates with an LVCMOS
interface that corresponds to the power supply voltage.
I/O Quick Configuration
To facilitate the most efficient board test, the physical nature of the I/O cells must be set before running any continu-
ity tests. As these tests are fast, by nature, the overhead and time that is required for configuration of the I/Os’
physical nature should be minimal so that board test time is minimized. The ispMACH 4000 family of devices allows
this by offering the user the ability to quickly configure the physical nature of the I/O cells. This quick configuration
takes milliseconds to complete, whereas it takes seconds for the entire device to be programmed. Lattice's ispVM
System programming software can either perform the quick configuration through the PC parallel port, or can gen-
erate the ATE or test vectors necessary for a third-party test system.
Shared PTOE
(Block 0)
Shared PTOE
(Block 1)
2
low power cell and non sense-amplifier design approach (full CMOS logic
Internal Global OE
(2 lines)
PT Bus
Fuse connection
Hard wired
13
Global OE
Global
Fuses
ispMACH 4000V/B/C/Z Family Data Sheet
Global OE Bus
to I/O cells
GOE (3:0)
4-Bit
®