XC2VP7-5FF672C Xilinx Inc, XC2VP7-5FF672C Datasheet - Page 65

• Manufacturer Part Number: XC2VP7-5FF672C
• Description: FPGA Virtex-II Pro™ Family 11088 Cells 1050MHz 0.13um/90nm (CMOS) Technology 1.5V 672-Pin FCBGA
• Manufacturer: Xilinx Inc

Specifications of XC2VP7-5FF672C

• Package: 672FCBGA
• Family Name: Virtex-II Pro™
• Device Logic Units: 11088
• Number Of Registers: 9856
• Maximum Internal Frequency: 1050 MHz
• Typical Operating Supply Voltage: 1.5 V
• Maximum Number Of User I/os: 396
• Ram Bits: 811008

Routing
DCM and MGT Locations/Organization
Virtex-II Pro DCMs and serial transceivers (MGTs) are
placed on the top and bottom of each block RAM and multi-
plier column in some combination, as shown in
The number of DCMs and RocketIO transceivers total twice
the number of block RAM columns in the device. Refer to
Figure 52, page 47
device.
Table 31: DCM and MGT Organization
DS083 (v4.7) November 5, 2007
Product Specification
XC2VP2
XC2VP4
XC2VP7
XC2VP20
XC2VPX20
XC2VP30
XC2VP40
XC2VP50
XC2VP70
XC2VPX70
XC2VP100
Device
R
Block RAM
Columns
24 Horizontal Long Lines
24 Vertical Long Lines
120 Horizontal Hex Lines
120 Vertical Hex Lines
40 Horizontal Double Lines
40 Vertical Double Lines
16 Direct Connections
(total in all four directions)
8 Fast Connects
for an illustration of this in the XC2VP4
10
12
14
14
16
4
4
6
8
8
8
DCMs
12
4
4
4
8
8
8
8
8
8
8
Figure 64: Hierarchical Routing Resources
Virtex-II Pro and Virtex-II Pro X Platform FPGAs: Functional Description
MGTs
Table
12
16
20
20
20
4
4
8
8
8
8
www.xilinx.com
31.
Place-and-route software takes advantage of this regular
array to deliver optimum system performance and fast com-
pile times. The segmented routing resources are essential
to guarantee IP cores portability and to efficiently handle an
incremental design flow that is based on modular imple-
mentations. Total design time is reduced due to fewer and
shorter design iterations.
Hierarchical Routing Resources
Most Virtex-II Pro signals are routed using the global rout-
ing resources, which are located in horizontal and vertical
routing channels between each switch matrix.
As shown in
ered programmable interconnections, with a number of
resources counted between any two adjacent switch matrix
rows or columns. Fanout has minimal impact on the perfor-
mance of each net.
•
•
The long lines are bidirectional wires that distribute
signals across the device. Vertical and horizontal long
lines span the full height and width of the device.
The hex lines route signals to every third or sixth block
away in all four directions. Organized in a staggered
pattern, hex lines can only be driven from one end.
Hex-line signals can be accessed either at the
endpoints or at the midpoint (three blocks from the
source).
Figure 64, page
54, Virtex-II Pro has fully buff-
DS031_60_110200
Module 2 of 4
54