SLXT973QC.A2 Intel, SLXT973QC.A2 Datasheet - Page 25
SLXT973QC.A2
Manufacturer Part Number
SLXT973QC.A2
Description
Manufacturer
Intel
Datasheet
1.SLXT973QC.A2.pdf
(88 pages)
Specifications of SLXT973QC.A2
Lead Free Status / RoHS Status
Not Compliant
- Current page: 25 of 88
- Download datasheet (2Mb)
3.3.4
3.3.5
3.3.6
3.3.7
3.3.7.1
3.3.7.2
Datasheet
Document #: 249426
Revision #: 002
Rev. Date: March 1, 2002
Carrier Sense
Carrier Sense (CRS) is an asynchronous output. CRS is generated when a packet is received from
the line regardless of duplex mode, and for a transmission to the line in half-duplex mode.
on page 26
signals. Carrier sense is not generated when a packet is transmitted in full-duplex mode.
For 100BASE-TX and 100BASE-FX links, a Start-of-Stream Delimiter (SSD) or /J/K/ symbol pair
causes assertion of carrier sense (CRS). An End-of-Stream Delimiter (ESD), or /T/R/ symbol pair
causes de-assertion of CRS. The PMA layer also de-asserts CRS if IDLE symbols are received
without /T/R/. In this event, the RXER bit in the RX Status Frame is asserted for one clock cycle
when CRS is de-asserted.
For 10BASE-T links, CRS assertion is based on receipt of a valid preamble, and de-assertion is
based on receipt of an End-of-Frame (EOF) marker.
Error Signals
When the LXT973 is in 100 Mbps mode and receives an invalid symbol from the network, it
asserts RXER and drives “1110” on the RXD pins.
When the MAC asserts TXER, the LXT973 drives “H” symbols out on the DPAP/N_0 or
DPAP/N_1 pins.
Collision
The LXT973 asserts its collision signal, asynchronously to any clock, when the line state is half-
duplex and the transmitter and receiver are active at the same time.
the conditions for assertion of carrier sense, collision, and data loopback signals.
Loopback
The LXT973 provides two loopback functions, operational and test (see
Loopback paths are shown in
Operational Loopback
Operational loopback is provided for 10 Mbps half-duplex links when Register bit 16.8 = 0. Data
transmitted by the MAC (TXD) is looped back on the receive side of the MII (RXD). Operational
loopback is not provided for 100 Mbps links, full-duplex links, or when Register bit 16.8 = 1.
Test Loopback
A test loopback function is provided for diagnostic testing of the LXT973. During test loopback,
twisted-pair and fiber interfaces are disabled. Data transmitted by the MAC is internally looped
back by the LXT973 and returned to the MAC.
Test loopback is available for both 100BASE-TX and 10BASE-T operation. Test loopback is
enabled by setting the register bits as follows:
•
Register bit 0.14 = 1 (loopback mode)
summarizes the conditions for assertion of carrier sense, collision, and data loopback
LXT973 10/100 Mbps Dual-Port Fast Ethernet PHY Transceiver
Figure 4 on page
26.
Table 8 on page 26
Table 8 on page
summarizes
26).
Table 8
25
Related parts for SLXT973QC.A2
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Microprocessor: Intel Celeron M Processor 320 and Ultra Low Voltage Intel Celeron M Processor at 600MHz
Manufacturer:
Intel Corporation
Part Number:
Description:
Intel 82550 Fast Ethernet Multifunction PCI/CardBus Controller
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
Intel StrataFlash memory 32 Mbit. Access speed 120 ns
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
Intel StrataFlash memory 32 Mbit. Access speed 120 ns
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
Intel StrataFlash memory 64 Mbit. Access speed 150 ns
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
Intel StrataFlash memory 32 Mbit. Access speed 100 ns
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
DA28F640J5A-1505 Volt Intel StrataFlash Memory
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
5 Volt Intel StrataFlash?? Memory
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
5 Volt Intel StrataFlash?? Memory
Manufacturer:
Intel Corporation
Part Number:
Description:
Intel 6300ESB I/O Controller Hub
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
Intel 82801DB I/O Controller Hub (ICH4), Pb-Free SLI
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
Intel 82801FB I/O Controller Hub (ICH6)
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
Intel Strataflash Memory28F128J3 28F640J3 28F320J3
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
Controllers, Intel 430TX PCIset: 82439TX System Controller (MTXC)
Manufacturer:
Intel Corporation