5962-8961403MXA E2V, 5962-8961403MXA Datasheet - Page 17

• Manufacturer Part Number: 5962-8961403MXA
• Manufacturer: E2V

Specifications of 5962-8961403MXA

• Lead Free Status / RoHS Status: Supplier Unconfirmed

DSCC FORM 2234
APR 97
MIL-PRF-38535, MIL-HDBK-1331, and as follows.
subscripts. The initial character is always "t" and is followed by four descriptors. These characters specify two signal points
arranged in a "from-to" sequence that define a timing interval. The two descriptors for each signal specify the signal name and
the signal transition. Thus the format is:
requirements are specified from the external system point of view. Thus, address setup time is shown as a minimum since the
system must supply at least that much time (even though most devices do not require it). On the other hand, responses from
the memory are specified from the device point of view. Thus, the access time is shown as a maximum since the device never
provides data later than that time.
6.5 Abbreviations, symbols, and definitions. The abbreviations, symbols, and definitions used herein are defined in
6.5.1 Timing parameter abbreviations. All timing abbreviations use lower case characters with upper case character
Signal name from which interval is defined
Transition direction for first signal
Signal name to which interval is defined
Transition direction for second signal
6.5.2 Timing limits. The table of timing values shows either a minimum or a maximum limit for each parameter. Input
6.4 Comments. Comments on this drawing should be directed to DSCC-VA , Columbus, Ohio 43216-5000, or telephone
C
GND --------------------------------------
I
I
T
V
O/V ---------------------------------------
a.
b.
CC
LI
[phone].
C
CC
IN
DEFENSE SUPPLY CENTER COLUMBUS
, C
-----------------------------------------
-----------------------------------------
-----------------------------------------
Signal definitions:
A = Address
D = Data in
Q = Data out
W = Write enable
E = Chip enable
Transition definitions:
H = Transition to high
L = Transition to low
V = Transition to valid
X = Transition to invalid or don't care
Z = Transition to off (high impedance)
---------------------------------------
OUT
MICROCIRCUIT DRAWING
COLUMBUS, OHIO 43216-5000
---------------------------------
STANDARD
Input and bidirectional output, terminal-to-GND capacitance.
Ground zero voltage potential.
Supply current.
Input load current
Case temperature.
Positive supply voltage.
Latchup over-voltage
t
X
│
X
│
│
SIZE
X
│
│
│
│
A
X
│
│
│
│
│
│
│
REVISION LEVEL
F
SHEET
5962-89614
17