MK2049-45SILF IDT, Integrated Device Technology Inc, MK2049-45SILF Datasheet - Page 6

• Manufacturer Part Number: MK2049-45SILF
• Description: IC CLK PLL COMM 3.3V 20-SOIC
• Manufacturer: IDT, Integrated Device Technology Inc
• Type: PLL Clock Synthesizerr

Specifications of MK2049-45SILF

• Pll: Yes
• Input: Clock
• Output: Clock
• Number Of Circuits: 1
• Ratio - Input:output: 1:3
• Differential - Input:output: No/No
• Frequency - Max: 49.152MHz
• Divider/multiplier: Yes/Yes
• Voltage - Supply: 3.15 V ~ 3.45 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 20-SOIC
• Frequency-max: 49.152MHz
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

the CHGP and VIN pins. C
Coupling of noise from other system signal traces should be
minimized by keeping traces short and away from active
signal traces. Use of vias should be avoided.
3) The external crystal should be mounted just next to the
device with short traces. The X1 and X2 traces should not
be routed next to each other with minimum spaces, instead
they should be separated and away from other traces.
4) To minimize EMI the 33 Ω series termination resistor, if
needed, should be placed close to the clock output.
5) An optimum layout is one with all components on the
Absolute Maximum Ratings
Recommended Operation Conditions
IDT™ / ICS™ 3.3 VOLT COMMUNICATIONS CLOCK PLL
MK2049-45
3.3 VOLT COMMUNICATIONS CLOCK PLL
Stresses above the ratings listed below can cause permanent damage to the MK2049-45. These ratings, which are
standard values for ICS commercially rated parts, are stress ratings only. Functional operation of the device at
these or any other conditions above those indicated in the operational sections of the specifications is not implied.
Exposure to absolute maximum rating conditions for extended periods can affect product reliability. Electrical
parameters are guaranteed only over the recommended operating temperature range.
Supply Voltage, VDD
All Inputs and Outputs
Ambient Operating Temperature
Storage Temperature
Junction Temperature
Soldering Temperature
Parameter
Ambient Operating Temperature
Power Supply Voltage (measured in respect to GND)
P
should be closest to the device.
Item
6
same side of the board, minimizing vias through other signal
layers (the ferrite bead and bulk decoupling capacitor can be
mounted on the back). Other signal traces should be routed
away from the MK2049-45. This includes signal traces just
underneath the device, or on layers adjacent to the ground
plane layer used by the device.
MAN05 may also be referenced for additional suggestions
on layout of the crystal section.
+3.15
Min.
-40
7 V
-0.5 V to VDD+0.5 V
-40 to +85°C
-65 to +150°C
125°C
250°C
Typ.
+3.3
Rating
+3.45
Max.
+85
VCXO AND SYNTHESIZER
MK2049-45
Units
°C
V
REV G 101904