CS4334-DSZ Cirrus Logic Inc, CS4334-DSZ Datasheet - Page 22

• Manufacturer Part Number: CS4334-DSZ
• Description: IC DAC STER 24BIT 96KHZ 8-SOIC
• Manufacturer: Cirrus Logic Inc

Specifications of CS4334-DSZ

• Data Interface: Serial
• Number Of Bits: 24
• Number Of Converters: 2
• Voltage Supply Source: Single Supply
• Power Dissipation (max): 104mW
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC
• Resolution (bits): 24bit
• Sampling Rate: 96kSPS
• Input Channel Type: Serial
• Supply Voltage Range - Analog: 4.75V To 5.5V
• Supply Current: 15mA
• Digital Ic Case Style: SOIC
• Package: 8SOIC
• Resolution: 24 Bit
• Conversion Rate: 96 KSPS
• Architecture: Delta-Sigma
• Digital Interface Type: Serial
• Number Of Outputs Per Chip: 2
• Output Type: Voltage
• Full Scale Error: ±5(Typ) %FSR
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 598-1510 - BOARD EVAL FOR CS4334 CODEC
• Settling Time: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 598-1631

22
5. PARAMETER DEFINITIONS
Total Harmonic Distortion + Noise (THD+N)
Dynamic Range
Interchannel Isolation
Interchannel Gain Mismatch
Gain Error
Gain Drift
6. REFERENCES
1. "How to Achieve Optimum Performance from Delta-Sigma A/D & D/A Converters" by Steven Harris. Paper
2. CDB4334/5/8/9 Evaluation Board Datasheet
The ratio of the rms value of the signal to the rms sum of all other spectral components over the specified
bandwidth (typically 10Hz to 20kHz), including distortion components. Expressed in decibels.
The ratio of the full scale rms value of the signal to the rms sum of all other spectral components over the
specified bandwidth. Dynamic range is a signal-to-noise measurement over the specified bandwidth made
with a -60 dBFS signal. 60 dB is then added to the resulting measurement to refer the measurement to full
scale. This technique ensures that the distortion components are below the noise level and do not effect the
measurement. This measurement technique has been accepted by the Audio Engineering Society, AES17-
1991, and the Electronic Industries Association of Japan, EIAJ CP-307.
A measure of crosstalk between the left and right channels. Measured for each channel at the converter's
output with all zeros to the input under test and a full-scale signal applied to the other channel. Units in deci-
bels.
The gain difference between left and right channels. Units in decibels.
The deviation from the nominal full-scale analog output for a full-scale digital input.
The change in gain value with temperature. Units in ppm/°C.
presented at the 93rd Convention of the Audio Engineering Society, October 1992.
Confidential Draft
3/11/08
CS4334/5/8/9
DS248F5