EZ80L92AZ050SG Zilog, EZ80L92AZ050SG Datasheet - Page 41

• Manufacturer Part Number: EZ80L92AZ050SG
• Description: IC WEBSERVER 50MHZ 100LQFP
• Manufacturer: Zilog

Specifications of EZ80L92AZ050SG

• Processor Type: eZ80
• Features: High Speed, Single-Cycle Instruction-Fetch
• Speed: 50MHz
• Voltage: 3.3V
• Mounting Type: Surface Mount
• Package / Case: 100-LQFP
• Processor Series: EZ80L92x
• Core: eZ80
• Data Bus Width: 8 bit
• Program Memory Size: 64 KB
• Interface Type: I2C, SPI, UART
• Maximum Clock Frequency: 50 MHz
• Number Of Programmable I/os: 24
• Number Of Timers: 6
• Operating Supply Voltage: 3 V to 3.6 V
• Maximum Operating Temperature: + 70 C
• Mounting Style: SMD/SMT
• Development Tools By Supplier: eZ80L920210ZCO
• Minimum Operating Temperature: 0 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 269-3878; EZ80L92AZ050SG

PS013014-0107
Clock Peripheral Power-Down Registers
The eZ80 CPU can be brought out of HALT mode by any of the following operations:
•
•
•
•
•
To minimize current in HALT mode, the system clock must be disabled for all unused on-
chip peripherals through the Clock Peripheral Power-Down Registers.
To reduce power, the Clock Peripheral Power-Down Registers allow the system clock to
be disabled to unused on-chip peripherals. On RESET, all peripherals are enabled. The
clock to unused peripherals can be disabled by setting the appropriate bit in the Clock
Peripheral Power-Down Registers to 1. When powered down, the peripherals are com-
pletely disabled. To re-enable, the bit in the Clock Peripheral Power-Down Registers must
be cleared to 0.
Many peripherals feature separate enable/disable control bits that must be appropriately
set for operation. These peripheral specific enable/disable bits do not provide the same
level of power reduction as the Clock Peripheral Power-Down Registers. When powered
down, the standard peripheral control registers are not accessible for Read or Write access.
See
Non-maskable interrupt (NMI).
Maskable interrupt.
RESET through the external RESET pin driven Low.
Watchdog Timer time-out (if configured to generate either an NMI or RESET upon
time-out).
RESET through execution of a Debug RESET command.
Table 4
and
Table
5.
Product Specification
Low-Power Modes
35