Tactile & Jog Switches 50 mAmps at 12 Volts

SKQBASA010

Manufacturer Part NumberSKQBASA010
DescriptionTactile & Jog Switches 50 mAmps at 12 Volts
ManufacturerALPS
SeriesSKQB
SKQBASA010 datasheet
 


Specifications of SKQBASA010

Operating Force2.55 NActuatorStem
Contact Rating50 mAmps at 12 VoltsTermination StyleSnap In
Mounting DirectionVerticalMounting StyleSnap In
Lead Free Status / Rohs StatusLead free / RoHS Compliant  
1
Page 1
2
Page 2
3
Page 3
4
Page 4
Page 4/4

Download datasheet (239Kb)Embed
Prev
TACT Switch
TM
Soldering Conditions
Condition for Reflow
Available for Surface Mount Type.
1. Heating method: Double heating method with infrared heater.
2. Temperature measurement: Thermocouple 0.1 to 0.2φ CA (K) or CC (T) at solder joints ( copper foil surface) . A heat resistive tape
Detector
3. Temperature profile
Push
Temperature (˚C )
Slide
Rotary
Encoders
Power
Dual-in-line
Package Type
TM
TACT Switch
Custom-
Products
Note
1. The above temperature shall be measured on the mounting surface of a PC board. There are cases where the PC
board's temperature greatly differs from that of the switch, depending on the material, size, thickness of PC boards
and others. The above-stated conditions shall also apply to switch surface temperatures.
2. Soldering conditions differ depending on reflow soldering machines. Prior verification of soldering condition is
highly recommended.
Sharp
Feeling
Conditions for Auto-dip
Soft
Available for Snap-in Type and Radial Type
Feeling
(Except SKHJ, SKHL, SKQJ, SKQK, SKEG series)
Snap-in
Type
Items
Surface
Mount Type
Flux built-up
Radial
Type
Ambient temperature of the soldered
Preheating temperature
Preheating time
Soldering temperature
Duration of immersion
Number of soldering
Notes
1. Consult with us for availability of TACT Switch
2. Prevent flux penetration from the top side of the TACT Switch
3. Switch terminals and a PC board should not be coated with flux prior to soldering.
4. The second soldering should be done after the switch is stable with normal temperature.
5. Use the flux with a specific gravity of min 0.81.
(EC-19S-8 by TAMURA Corporation, or equivalents.)
306
should be used to fix thermocouple.
180
150
120 sec max. ( pre-heating )
3 to 4min.
Time inside soldering equipment
Manual Soldering(Except SKRT Series)
Soldering temperature
Condition
Duration of soldering
Mounting surface
should not be exposed to fluk
Capacity of soldering iron
surface of PC board.
100℃ max.
60s max.
260℃ max.
5s max.
2times max.
TM
washing.
TM
260˚C max. 3 sec max.
230˚C
Time
40s max.
Items
Condition
350℃max.
3s max.
60W max.
.