MAX3232ESE+ Maxim, MAX3232ESE+ Datasheet
MAX3232ESE+
Specifications of MAX3232ESE+
Related parts for MAX3232ESE+
MAX3232ESE+ Summary of contents
Page 1
... Cell-Phone Data Cables xDSL Modems Notebook, Subnotebook, and Palmtop Computers ________________________________________________________________ Maxim Integrated Products For pricing, delivery, and ordering information, please contact Maxim/Dallas Direct! at 1-888-629-4642, or visit Maxim’s website at www.maxim-ic.com. Next-Generation Device Features ♦ For Space-Constrained Applications MAX3228E/MAX3229E: ±15kV ESD-Protected, +2.5V to +5.5V, RS-232 Transceivers in UCSP ♦ ...
Page 2
... Preheating is required. Hand or wave soldering is not allowed. Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability ...
Page 3
ESD-Protected, Down to 10nA, 3.0V to 5.5V 1Mbps, True RS-232 Transceivers ELECTRICAL CHARACTERISTICS (continued +3V to +5.5V, C1–C4 = 0.1µ PARAMETER Output-Voltage High I OUT RECEIVER INPUTS Input Voltage Range Input Threshold ...
Page 4
... TIMING CHARACTERISTICS—MAX3237E (V = +3V to +5.5V, C1–C4 = 0.1µ PARAMETER R L MBAUD = GND V CC Maximum Data Rate one transmitter switching, MBAUD = one transmitter switching, MBAUD = V Receiver Propagation Delay R_IN to R_OUT, C Receiver Output Enable Time Normal operation Receiver Output Disable Time Normal operation ...
Page 5
ESD-Protected, Down to 10nA, 3.0V to 5.5V 1Mbps, True RS-232 Transceivers __________________________________________Typical Operating Characteristics (V = +3.3V, 250kbps data rate, 0.1µF capacitors, all transmitters loaded with 3kΩ and C CC MAX3222E/MAX3232E TRANSMITTER OUTPUT VOLTAGE vs. LOAD CAPACITANCE ...
Page 6
ESD-Protected, Down to 10nA, 3.0V to 5.5V 1Mbps, True RS-232 Transceivers (V = +3.3V, 250kbps data rate, 0.1µF capacitors, all transmitters loaded with 3kΩ and C CC MAX3237E SLEW RATE vs. LOAD CAPACITANCE (MBAUD = GND) 12 ...
Page 7
ESD-Protected, Down to 10nA, 3.0V to 5.5V 1Mbps, True RS-232 Transceivers MAX3222E MAX3232E SO/DIP/ SO/ TSSOP/ SSOP/ TQFN TQFN DIP SSOP 16-PIN TSSOP — — ...
Page 8
ESD-Protected, Down to 10nA, 3.0V to 5.5V 1Mbps, True RS-232 Transceivers MAX3222E MAX3232E SO/DIP/ SO/ TSSOP/ SSOP/ TQFN TQFN DIP SSOP 16-PIN TSSOP — ...
Page 9
... 1000pF 3kΩ (2500pF, MAX3237E only) MAXIMUM SLEW-RATE TEST CIRCUIT into a high-impedance state when the device is in shut- down mode (SHDN = GND). The MAX3222E/ MAX3232E/MAX3237E/MAX3241E/MAX3246E permit the outputs to be driven up to ±12V in shutdown. The MAX3222E/MAX3232E/MAX3241E/MAX3246E transmitter inputs do not have pullup resistors. Connect unused inputs to GND or V range ...
Page 10
... ESD of ±15kV without damage. The ESD structures withstand high ESD in all states: normal operation, shutdown, and powered down. After an ESD event, Maxim’s E versions keep working without latchup, whereas competing RS-232 products can latch and must be powered down to remove latchup. ...
Page 11
ESD-Protected, Down to 10nA, 3.0V to 5.5V 1Mbps, True RS-232 Transceivers Table 1. MAX3222E/MAX3237E/MAX3241E/ MAX3246E Shutdown and Enable Control Truth Table SHDN EN T_OUT R_OUT High 0 0 Active impedance High High 0 1 impedance impedance 1 ...
Page 12
... Human Body Model. ESD Test Conditions ESD performance depends on a variety of conditions. Contact Maxim for a reliability report that documents test setup, test methodology, and test results. Human Body Model Figure 4a shows the Human Body Model, and Figure 4b shows the current waveform it generates when dis- charged into a low impedance ...
Page 13
ESD-Protected, Down to 10nA, 3.0V to 5.5V 1Mbps, True RS-232 Transceivers V = +3.0V TO +5. Figure ...
Page 14
ESD-Protected, Down to 10nA, 3.0V to 5.5V 1Mbps, True RS-232 Transceivers Transmitter Outputs Recovering Figure 3 shows two transmitter outputs recovering from shutdown mode. As they become active, the two trans- mitter outputs are shown going to ...
Page 15
... UCSP reliability performance. In conclusion, the UCSP is capable of performing reliably through envi- ronmental stresses as indicated by the results in the table. Additional usage data and recommendations are detailed in the UCSP application note, which can be found on Maxim’s website at www.maxim-ic.com. CONDITIONS = -35°C to +85°C, = -40°C to +100°C = +70°C = +20° ...
Page 16
ESD-Protected, Down to 10nA, 3.0V to 5.5V 1Mbps, True RS-232 Transceivers __________________________________________________________Pin Configurations TOP VIEW EN 1 SHDN C1 C1 GND V+ C1- T1OUT 4 15 C1- MAX3222E ...
Page 17
ESD-Protected, Down to 10nA, 3.0V to 5.5V 1Mbps, True RS-232 Transceivers TOP VIEW GND SHDN 18 MAX3222E EN 19 EXPOSED PADDLE TQFN TOP VIEW (BUMPS ...
Page 18
ESD-Protected, Down to 10nA, 3.0V to 5.5V 1Mbps, True RS-232 Transceivers __________________________________________________Typical Operating Circuits +3. BYPASS C1 0.1µF C1- MAX3222E 5 C2 0.1µF C2- 12 T1IN TTL/CMOS INPUTS ...
Page 19
ESD-Protected, Down to 10nA, 3.0V to 5.5V 1Mbps, True RS-232 Transceivers _____________________________________Typical Operating Circuits (continued) +3.3V C BYPASS C1+ 0.1µF 25 C1- MAX3237E 1 C2+ 0.1µF 3 C2- T1IN 24 T1 T2IN 23 ...
Page 20
ESD-Protected, Down to 10nA, 3.0V to 5.5V 1Mbps, True RS-232 Transceivers _____________________________________Typical Operating Circuits (continued) +3.3V TTL/CMOS TTL/CMOS OUTPUTS 20 ______________________________________________________________________________________ C BYPASS C1 0.1µF F4 C1- MAX3246E E1 C2+ V- ...
Page 21
... MAX3246EEBX-T -40°C to +85°C † Requires solder temperature profile described in the Absolute Maximum Ratings section. UCSP Reliability is integrally linked to the user’s assembly methods, circuit board material, and environment. Refer to the UCSP Reliability Notice in the UCSP Reliability section of this datasheet for more information. ...
Page 22
... ESD-Protected, Down to 10nA, 3.0V to 5.5V 1Mbps, True RS-232 Transceivers (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information www.maxim-ic.com/packages.) 22 ______________________________________________________________________________________ Package Information PACKAGE OUTLINE, 12, 16, 20, 24, 28L THIN QFN, 4x4x0.8mm ...
Page 23
... ESD-Protected, Down to 10nA, 3.0V to 5.5V 1Mbps, True RS-232 Transceivers (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information www.maxim-ic.com/packages.) ______________________________________________________________________________________ Package Information (continued) PACKAGE OUTLINE, TSSOP 4.40mm BODY 21-0066 ...
Page 24
... ESD-Protected, Down to 10nA, 3.0V to 5.5V 1Mbps, True RS-232 Transceivers (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information www.maxim-ic.com/packages.) 24 ______________________________________________________________________________________ Package Information (continued) PACKAGE OUTLINE, 6x6 UCSP 21-0082 ...
Page 25
... ESD-Protected, Down to 10nA, 3.0V to 5.5V 1Mbps, True RS-232 Transceivers (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information www.maxim-ic.com/packages TOP VIEW D e FRONT VIEW NOTES: 1. D&E DO NOT INCLUDE MOLD FLASH. ...
Page 26
... Pages changed at Rev 10: 1–4, 9, 11, 21, 22, 26 Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. ...