ELC-485APTR

Manufacturer Part NumberELC-485APTR
DescriptionACCESSORY; ELC RS-485 ADAPTER CONNECT DB9 TO RJ12 TO 2-PIN PLUG
ManufacturerEaton / Control Automation
TypeCommunications
ELC-485APTR datasheet
 


Specifications of ELC-485APTR

Brand/seriesELCPrimary TypeOption
For Use WithMicro Controllers  
1
Page 1
2
Page 2
Page 1/2

Download datasheet (437Kb)Embed
Next
ELC-485APTR
RS-485 Interface Adpater
1
ELC-485APTR is an OPEN-TYPE. Please place the module in an enclosure away from airborne dust or high humidity
and prevent electric shock or sudden collision on ELC-485APTR. Also, it is equipped with protective methods such as
some special tool or key to open the enclosure, so as to avoid the hazard to users or any damage to the module. Do
NOT touch terminals when power on.
I/O terminal screws should be tightened to between 1.95 kg-cm (1.7 in-lbs). Use copper conductor only, 60
2
ELC-485APTR is mainly designed to connect Eaton product by RS-485 interface. It is equipped with surge absorber and
limited current protection to ensure safe connection of different devices. Also, a switch enabled built-in terminator (120Ω).
Environmental Specification:
0℃~55℃(Temperature), 50~95%(Humidity), pollutant degree 2
Operation
-25℃~70℃(Temperature), 5~95%(Humidity)
Storage
Vibration/Shock resistance
International Standard: IEC1131-2, IEC 68-2-6(TEST Fc)/ IEC1131-2 & IEC 68-2-27 (TEST Ea)
Product profile:
1
2
3
4
5
32
60
6
Units: mm
Fig. 1: Profile and Dimensions
3
ELC-485APTR Connection with Eaton Products
Connection of ELC-485APTR and AC Motor Drive (please see AC motor drive user manual for detail information)
MVX 9000
Instruction sheet
WARNING
INTRODUCTION
6
1. Mounting plate
7
2. COM 1 (DB9 female)
8
3. COM 2 (DB9 male)
4. Nameplate
5. ON/OFF of termination resistor (factory
6. DIN rail (35mm)
7. RS-485 port
3,4
8. RJ12 port
RS-485 Network
Fig. 2: ELC controller connection with MVX9000
1
IL05003022E.pdf
o
C / 75
setting: OFF)
o
C.

ELC-485APTR Summary of contents

  • Page 1

    ... I/O terminal screws should be tightened to between 1.95 kg-cm (1.7 in-lbs). Use copper conductor only ELC-485APTR is mainly designed to connect Eaton product by RS-485 interface equipped with surge absorber and limited current protection to ensure safe connection of different devices. Also, a switch enabled built-in terminator (120Ω). ...

  • Page 2

    ... Compact Installation reference: See Fig lower left, when ELC-485APTR is separated from mounting plate, it can be used as the last extension module with its RS-485 port connecting to ELC controller’s (see Fig. 3b for illustration). This connection is feasible for ELC controller to connect AC Motor Drive within 5 meters. ...