MC68HC711KS2MFN4 Freescale Semiconductor, MC68HC711KS2MFN4 Datasheet - Page 154

no-image

MC68HC711KS2MFN4

Manufacturer Part Number
MC68HC711KS2MFN4
Description
32K EPROM - SLOW MODE
Manufacturer
Freescale Semiconductor
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
MC68HC711KS2MFN4
Manufacturer:
Freescale
Quantity:
300
Serial Communications Interface (SCI)
Technical Data
154
Figure 7-3
The overrun error (OR) flag is set instead of the RDRF bit when
the next byte is ready to be transferred from the receive shift
register to the RDR and the RDR is already full. The data in the
shift register is lost and the data that was already in RDR is not
disturbed.
The noise flag (NF) is set if there is noise on any of the received
bits, including the start and stop bits. The data recovery circuit
takes three samples of each bit and indicates noise if any set of
three samples is not unanimous. NF is not set until the entire
character is received and transferred to the RDR, when RDRF is
set.
The framing error (FE) flag is set when no stop bit is detected in
the received data character. FE is set at the same time as RDRF.
If the byte received causes both framing and overrun errors, the
processor only recognizes the overrun error. The framing error
flag inhibits further data transfer into the RDR until the flag is
cleared.
The parity error (PE) flag indicates that the parity bit of a received
character does not match the parity calculated by hardware.
The receiver active flag (RAF) is a read-only bit that is set during
data reception and cleared when the line goes idle. This is the only
flag cleared by hardware.
Serial Communications Interface (SCI)
is a block diagram of the SCI receiver.
M68HC11K Family
MOTOROLA

Related parts for MC68HC711KS2MFN4