JM38510/19007BEA Intersil, JM38510/19007BEA Datasheet - Page 37

• Manufacturer Part Number: JM38510/19007BEA
• Description: Analog Multiplexer Single 8:1 16-Pin CDIP
• Manufacturer: Intersil
• Type: Analog Multiplexerr

Specifications of JM38510/19007BEA

• Package: 16CDIP
• Maximum On Resistance: 300@±15V Ohm
• Maximum Propagation Delay Bus To Bus: 500@±15V ns
• Maximum High Level Output Current: 20 mA
• Multiplexer Architecture: 8:1
• Power Supply Type: Single|Dual

DSCC FORM 2234
APR 97
(original equipment), design applications, and logistics purposes.
prepared specification or drawing.
the individual documents. This coordination will be accomplished using DD Form 1692, Engineering Change Proposal.
application requires configuration control and the applicable SMD. DSCC will maintain a record of users and this list will be
used for coordination and distribution of changes to the drawings. Users of drawings covering microelectronics devices (FSC
5962) should contact DSCC-VA, telephone [phone].
[phone].
HDBK-103 have agreed to this drawing and a certificate of compliance (see 3.6 herein) has been submitted to and accepted by
DSCC-VA.
5. PACKAGING
5.1 Packaging requirements. The requirements for packaging shall be in accordance with MIL-PRF-38535, appendix A.
6. NOTES
6.1 Intended use. Microcircuits conforming to this drawing are intended for use for Government microcircuit applications
6.2 Replaceability. Microcircuits covered by this drawing will replace the same generic device covered by a contractor-
6.3 Configuration control of SMD's. All proposed changes to existing SMD's will be coordinated with the users of record for
6.4 Record of users. Military and industrial users shall inform Defense Supply Center Columbus (DSCC) when a system
6.5 Comments. Comments on this drawing should be directed to DSCC-VA, Columbus, Ohio 43218-3990, or telephone
6.6 Approved sources of supply. Approved sources of supply are listed in MIL-HDBK-103. The vendors listed in MIL-
DEFENSE SUPPLY CENTER COLUMBUS
MICROCIRCUIT DRAWING
COLUMBUS, OHIO 43218-3990
STANDARD
** Subgroups 10 and 11, if not tested, shall be guaranteed to the
Interim electrical parameters
Final electrical test parameters
Group A test requirements
Groups C and D end-point
MIL-STD-883 test requirements
* PDA applies to subgroup 1.
(method 5004)
(method 5004)
(method 5005)
electrical parameters
(method 5005)
specified limits in table I.
TABLE II. Electrical test requirements.
1
1*,2,3,9
1,2,3,4,7,9,10**,11**
1
MIL-STD-883, method 5005,
SIZE
A
(in accordance with
Subgroups
table I)
REVISION LEVEL
F
SHEET
5962-85131
37