ATA8202-PXQW 19 Atmel, ATA8202-PXQW 19 Datasheet - Page 19

• Manufacturer Part Number: ATA8202-PXQW 19
• Description: IC RX UHF ASK/FSK 433MHZ 24-VQFN
• Manufacturer: Atmel
• Series: -r

Specifications of ATA8202-PXQW 19

• Frequency: 433MHz
• Sensitivity: -113dBm
• Data Rate - Maximum: 9.6 kbps
• Modulation Or Protocol: ASK, FSK
• Applications: AMR, ISM, Security and Access
• Current - Receiving: 6.7mA
• Data Interface: *
• Memory Size: *
• Antenna Connector: *
• Features: -
• Voltage - Supply: 2.7 V ~ 3.3 V, 4.5 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 24-VQFN Exposed Pad
• Pin Count: 24
• Screening Level: Industrial
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: ATA8202-PXQW

4. Sensitivity Reduction
4971C–INDCO–04/09
The output voltage of the RSSI amplifier is internally compared to a threshold voltage V
V
the pins SENSE and VS3V_AVCC (see
is fed into the digital control logic. By this means, it is possible to operate the receiver at a lower
sensitivity.
If the level on input pin SENSE_CTRL is low, the receiver operates at full sensitivity.
If the level on input pin SENSE_CTRL is high, the receiver operates at a lower sensitivity. The
reduced sensitivity is defined by the value of R
nal-to-noise ratio of the LNA input. The reduced sensitivity depends on the signal strength at the
output of the RSSI amplifier.
Since different RF input networks may exhibit slightly different values for the LNA gain, the sen-
sitivity values given in the electrical characteristics refer to a specific input matching. This
matching is illustrated in
If the sensitivity reduction feature is not used, pin SENSE can be left open, pin SENSE_CTRL
must be set to GND.
To operate with reduced sensitivity, pin SENSE_CTRL must be set to high before the RX signal
path will be enabled by setting pin RX to high (see
level is lower than V
pin DATA_OUT (low level on pin DATA_OUT). An internal RS flip-flop will be set to high the first
time the RSSI voltage crosses V
DATA_OUT. From then on the receiver also works with full sensitivity. This makes sure that a
telegram will not be interrupted if the RSSI level varies during the transmission. The RS flip-flop
can be set back, and thus the receiver switched back to reduced sensitivity, by generating a pos-
itive pulse on pin ASK_NFSK (see
sensitivity follows the same way.
Th_red
is determined by the value of the external resistor R
Th_red
Figure 2-1 on page 7
(defined by the external resistor R
Th_red
Figure 4-2 on page
, and from then on the data stream will be available on pin
Figure 10-1 on page
and exhibits the best possible sensitivity.
Figure 4-1 on page
Sense
20). In FSK mode, operating with reduced
, the maximum sensitivity by the sig-
Sense
ATA8201/ATA8202
Sense
29). The output of the comparator
) no data stream is available on
. R
Sense
20). As long as the RSSI
is connected between
Th_red
19
.