CM05CG1R2B50AH

Manufacturer Part NumberCM05CG1R2B50AH
ManufacturerAVX Corporation
CM05CG1R2B50AH datasheet
 

Specifications of CM05CG1R2B50AH

Capacitance1.2pFTolerance (+ Or -)0.1pF
Voltage50VDCTemp Coeff (dielectric)C0G
Operating Temp Range-55C to 125CMounting StyleSurface Mount
Package / Case0402ConstructionSMT Chip
Case StyleCeramic ChipFailure RateNot Required
Wire FormNot RequiredProduct Length (mm)1mm
Product Depth (mm)0.5mmProduct Height (mm)0.55mm
Product Diameter (mm)Not RequiredmmLead Free Status / Rohs StatusCompliant
1
2
3
4
5
6
7
8
9
10
11
Page 11
12
Page 12
13
Page 13
14
Page 14
15
Page 15
16
Page 16
Page 15/16

Download datasheet (841Kb)Embed
PrevNext
Multilayer Ceramic Chip Capacitors
Surface Mounting Information
Mounting Design
The chip could crack if the PCB warps during processing after the chip has been soldered.
Recommended chip position on PCB to minimize stress from PCB warpage
(Not recommended)
Actual Mounting
1) If the position of the vacuum nozzle is too low, a large force may be applied to the chip capacitor during mounting, resulting in cracking.
2) During mounting, set the nozzle pressure to a static load of 100 to 300 gf.
3) To minimize the shock of the vaccum nozzle, provide a support pin on the back of the PCB to minimize PCB flexture.
Crack
4) Bottom position of pick up nozzle should be adjusted to the top surface of a substrate which camber is corrected.
5) To reduce the possibility of chipping and cracks, minimize vibration to chips stored in a bulk case.
6) The discharge pressure must be adjusted to the part size. Verify the pressure during setup to avoid fracturing or cracking the chips capacitors.
Resin Mold
1) If a large amount of resin is used for molding the chip, cracks may occur due to contraction stress during curing. To avoid such cracks, use a
low shrinkage resin.
2) The insulation resistance of the chip will degrade due to moisture absorption. Use a low moisture absorption resin.
3) Check carefully that the resin does not generate a decomposition gas or reaction gas during the curing process or during normal storage.
Such gases may crack the chip capacitor or damage the device itself.
(Ideal)
Support pin