M30622SFP Renesas Electronics America, M30622SFP Datasheet - Page 33

• Manufacturer Part Number: M30622SFP
• Manufacturer: Renesas Electronics America

Specifications of M30622SFP

• Cpu Family: M16C
• Device Core Size: 16/32Bit
• Frequency (max): 24MHz
• Interface Type: I2C/IEBus/UART
• Program Memory Type: ROMLess
• Program Memory Size: Not Required
• Total Internal Ram Size: 4KB
• # I/os (max): 87
• Number Of Timers - General Purpose: 11
• Operating Supply Voltage (typ): 3.3/5V
• Operating Supply Voltage (max): 5.5V
• Operating Supply Voltage (min): 3V
• On-chip Adc: 26-chx10-bit
• On-chip Dac: 2-chx8-bit
• Instruction Set Architecture: CISC
• Mounting: Surface Mount
• Pin Count: 100
• Package Type: PQFP
• Lead Free Status / Rohs Status: Not Compliant

M16C/62P Group (M16C/62P, M16C/62PT)
Rev.2.41
REJ03B0001-0241
2.2
2.3
2.4
2.5
2.6
2.7
2.8
2.8.1
2.8.2
2.8.3
2.8.4
2.8.5
2.8.6
2.8.7
The register A0 consists of 16 bits, and is used for address register indirect addressing and address register relative
addressing. They also are used for transfers and logic/logic operations. A1 is the same as A0.
In some instructions, registers A1 and A0 can be combined for use as a 32-bit address register (A1A0).
FB is configured with 16 bits, and is used for FB relative addressing.
INTB is configured with 20 bits, indicating the start address of an interrupt vector table.
PC is configured with 20 bits, indicating the address of an instruction to be executed.
Stack pointer (SP) comes in two types: USP and ISP, each configured with 16 bits.
Your desired type of stack pointer (USP or ISP) can be selected by the U flag of FLG.
SB is configured with 16 bits, and is used for SB relative addressing.
FLG consists of 11 bits, indicating the CPU status.
This flag retains a carry, borrow, or shift-out bit that has occurred in the arithmetic/logic unit.
The D flag is used exclusively for debugging purpose. During normal use, it must be set to “0”.
This flag is set to “1” when an arithmetic operation resulted in 0; otherwise, it is “0”.
This flag is set to “1” when an arithmetic operation resulted in a negative value; otherwise, it is “0”.
Register bank 0 is selected when this flag is “0” ; register bank 1 is selected when this flag is “1”.
This flag is set to “1” when the operation resulted in an overflow; otherwise, it is “0”.
This flag enables a maskable interrupt.
Maskable interrupts are disabled when the I flag is “0”, and are enabled when the I flag is “1”. The I flag
is cleared to “0” when the interrupt request is accepted.
Address Registers (A0 and A1)
Frame Base Register (FB)
Interrupt Table Register (INTB)
Program Counter (PC)
User Stack Pointer (USP) and Interrupt Stack Pointer (ISP)
Static Base Register (SB)
Flag Register (FLG)
Jan 10, 2006
Carry Flag (C Flag)
Debug Flag (D Flag)
Zero Flag (Z Flag)
Sign Flag (S Flag)
Register Bank Select Flag (B Flag)
Overflow Flag (O Flag)
Interrupt Enable Flag (I Flag)
Page 31 of 96
2. Central Processing Unit (CPU)