KVR1333D3LS4R9S/4GEC KINGSTON TECHNOLOGY, KVR1333D3LS4R9S/4GEC Datasheet
KVR1333D3LS4R9S/4GEC
Manufacturer Part Number
KVR1333D3LS4R9S/4GEC
Description
Manufacturer
KINGSTON TECHNOLOGY
Datasheet
1.KVR1333D3LS4R9S4GEC.pdf
(2 pages)
Specifications of KVR1333D3LS4R9S/4GEC
Lead Free Status / Rohs Status
Supplier Unconfirmed
KVR1333D3LS4R9S/4GEC
4GB 1Rx4 512M x 72-Bit PC3-10600
CL9 Registered w/Parity 240-Pin DIMM
DESCRIPTION
This document describes ValueRAM's 512M x 72-bit (4GB)
DDR3L-1333 CL9 SDRAM (Synchronous DRAM), low voltage,
registered w/parity, 1Rx4 ECC memory module, based on
eighteen 512M x 4-bit DDR3L-1333 FBGA components. The
SPD is programmed to JEDEC standard latency DDR3-1333
timing of 9-9-9 at 1.5V. This 240-pin DIMM uses gold contact
fingers. The electrical and mechanical specifications are as
follows:
FEATURES
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Memory Module Specifi cations
JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~
1.575V) Power Supply
VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V)
667MHz fCK for 1333Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 9, 8, 7, 6
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
On-DIMM thermal sensor (Grade B)
Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
Asynchronous Reset
PCB : Height 1.180” (30.00mm), double sided component
SPECIFICATIONS
CL(IDD)
Row Cycle Time (tRCmin)
Refresh to Active/Refresh
Command Time (tRFCmin)
Row Active Time (tRASmin)
Power (Operating)
UL Rating
Operating Temperature
Storage Temperature
*Power will vary depending on the SDRAM and
Register/PLL used.
DRAM Supported: Elpida C-Die
Document No. VALUERAM0994-001.B00
9 cycles
160ns (min.)
(1.35V) = TBD*
0
-55
49.5ns (min.)
36ns (min.)
(1.50V) = TBD*
94 V - 0
o
C to 85
o
C to +100
o
07/11/11
C
o
Continued >>
C
Page 1
Related parts for KVR1333D3LS4R9S/4GEC
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
FLASH DRIVE, USB 2.0 4GO KINGSTON
Manufacturer:
KINGSTON TECHNOLOGY
Part Number:
Description:
512MB PC2100 266MHZ DDR CL2.5 NON ECC
Manufacturer:
KINGSTON TECHNOLOGY
Part Number:
Description:
DRIVE, USB, 16GB, DATA TRAVELLER G5
Manufacturer:
KINGSTON TECHNOLOGY
Datasheet:
Part Number:
Description:
DRIVE, USB, 8GB, DATA TRAVELLER G4
Manufacturer:
KINGSTON TECHNOLOGY
Datasheet:
Part Number:
Description:
256MB PC2100 266MHZ DDR CL2.5 SODIMM
Manufacturer:
KINGSTON TECHNOLOGY
Part Number:
Description:
DRIVE, USB, 32GB, DATA TRAVELLER G6
Manufacturer:
KINGSTON TECHNOLOGY
Datasheet:
Part Number:
Description:
Manufacturer:
KINGSTON TECHNOLOGY
Datasheet:
Part Number:
Description:
Manufacturer:
KINGSTON TECHNOLOGY
Datasheet:
Part Number:
Description:
Manufacturer:
KINGSTON TECHNOLOGY
Datasheet:
Part Number:
Description:
Manufacturer:
KINGSTON TECHNOLOGY
Datasheet:
Part Number:
Description:
Manufacturer:
KINGSTON TECHNOLOGY
Datasheet:
KVR1333D3LS4R9S/4GEC Summary of contents
Page 1
... Memory Module Specifi cations KVR1333D3LS4R9S/4GEC 4GB 1Rx4 512M x 72-Bit PC3-10600 CL9 Registered w/Parity 240-Pin DIMM DESCRIPTION This document describes ValueRAM's 512M x 72-bit (4GB) DDR3L-1333 CL9 SDRAM (Synchronous DRAM), low voltage, registered w/parity, 1Rx4 ECC memory module, based on eighteen 512M x 4-bit DDR3L-1333 FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1333 timing of 9-9 ...
Page 2
... MODULE DIMENSIONS: (units = millimeters) Document No. VALUERAM0994-001.B00 Page 2 ...