MC68HC705J1A Mask Option Register - Motorola

no-image

MC68HC705J1A

Manufacturer Part Number
MC68HC705J1A
Description
Manufacturer
Motorola
Datasheet

Specifications of MC68HC705J1A

Case
DIP-20L
Memory
NOTE:
Writing logic 1s to both the ELAT and EPGM bits with a single instruction
sets ELAT and clears EPGM. ELAT must be set first by a separate
instruction.
Bits [7:3] — Reserved
Take these steps to program a byte of EPROM/OTPROM:
1. Apply the programming voltage, V
2. Set the ELAT bit.
3. Write to any EPROM/OTPROM address.
4. Set the EPGM bit and wait for a time, t
5. Clear the ELAT bit.
2.6.3 EPROM Erasing
The erased state of an EPROM bit is logic 0. Erase the EPROM by
exposing it to 15 Ws/cm
2537 angstroms. Position the ultraviolet light source one inch from the
EPROM. Do not use a shortwave filter.
2.7 Mask Option Register
The mask option register (MOR) is an EPROM/OTPROM byte that
controls these options:
Technical Data
40
2
of ultraviolet light with a wave length of
COP watchdog (enable or disable)
External interrupt pin triggering (edge-sensitive only or edge- and
level-sensitive)
Port A external interrupts (enable or disable)
Port pulldown resistors (enable or disable)
STOP instruction (stop mode or halt mode)
Crystal oscillator internal resistor (enable or disable)
EPROM security (enable or disable)
Short oscillator delay (enable or disable)
Memory
, to the IRQ/V
pin.
PP
PP
.
EPGM
MC68HC705J1A — Rev. 4.0
MOTOROLA

Related parts for MC68HC705J1A