AT89C5130A-M Atmel Corporation, AT89C5130A-M Datasheet - Page 126

• Manufacturer Part Number: AT89C5130A-M
• Manufacturer: Atmel Corporation

Specifications of AT89C5130A-M

• Flash (kbytes): 16 Kbytes
• Max. Operating Frequency: 48 MHz
• Cpu: 8051-12C
• Max I/o Pins: 34
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 1
• Twi (i2c): 1
• Uart: 1
• Sram (kbytes): 1.25
• Eeprom (bytes): 1024
• Self Program Memory: API
• Operating Voltage (vcc): 2.7 to 5.5
• Timers: 4
• Isp: UART/USB
• Watchdog: Yes

21.4.1
126
AT89C5130A/31A-M
Bulk/Interrupt OUT Transactions in Standard Mode
Figure 21-7. Bulk/Interrupt OUT transactions in Standard Mode
An endpoint will be first enabled and configured before being able to receive Bulk or Interrupt
packets.
When a valid OUT packet is received on an endpoint, the RXOUTB0 bit is set by the USB con-
troller. This triggers an interrupt if enabled. The firmware has to select the corresponding
endpoint, store the number of data bytes by reading the UBYCTLX and UBYCTHX registers. If
the received packet is a ZLP (Zero Length Packet), the UBYCTLX and UBYCTHX register val-
ues are equal to 0 and no data has to be read.
When all the endpoint FIFO bytes have been read, the firmware will clear the RXOUTB0 bit to
allow the USB controller to accept the next OUT packet on this endpoint. Until the RXOUTB0 bit
has been cleared by the firmware, the USB controller will answer a NAK handshake for each
OUT requests.
If the Host sends more bytes than supported by the endpoint FIFO, the overflow data won’t be
stored, but the USB controller will consider that the packet is valid if the CRC is correct and the
endpoint byte counter contains the number of bytes sent by the Host.
OUT
OUT
OUT
OUT
HOST
DATA0 (n bytes)
DATA1
DATA1
DATA1
ACK
NAK
NAK
ACK
UFI
RXOUTB0
RXOUTB0
Endpoint FIFO read byte 1
Endpoint FIFO read byte 2
Endpoint FIFO read byte n
Endpoint FIFO read byte 1
Clear RXOUTB0
C51
4337K–USB–04/08