ATmega1284RZAP Atmel Corporation, ATmega1284RZAP Datasheet - Page 253

• Manufacturer Part Number: ATmega1284RZAP
• Manufacturer: Atmel Corporation

Specifications of ATmega1284RZAP

• Flash (kbytes): 128 Kbytes
• Max. Operating Frequency: 20 MHz
• Max I/o Pins: 32
• Spi: 3
• Twi (i2c): 1
• Uart: 2
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 15
• Analog Comparators: 1
• Crypto Engine: No
• Sram (kbytes): 16
• Eeprom (bytes): 4096
• Operating Voltage (vcc): 1.8 to 3.6
• Timers: 3
• Frequency Band: 2.4 GHz
• Max Data Rate (mb/s): 0.25
• Antenna Diversity: No
• External Pa Control: No
• Power Output (dbm): 3
• Receiver Sensitivity (dbm): -101
• Receive Current Consumption (ma): 16.0
• Transmit Current Consumption (ma): 17.0
• Link Budget (dbm): 104

21.8
8059D–AVR–11/09
ADC Conversion Result
After the conversion is complete (ADIF is high), the conversion result can be found in the ADC
Result Registers (ADCL, ADCH).
For single ended conversion, the result is
where V
Table 21-3 on page 255
0x3FF represents the selected reference voltage minus one LSB.
If differential channels are used, the result is
where V
GAIN the selected gain factor, and V
in two’s complement form, from 0x200 (-512d) through 0x1FF (+511d). Note that if the user
wants to perform a quick polarity check of the results, it is sufficient to read the MSB of the result
(ADC9 in ADCH). If this bit is one, the result is negative, and if this bit is zero, the result is posi-
tive.
Table 21-2 on page 254
(ADCn - ADCm) is selected with a gain of GAIN and a reference voltage of V
Figure 21-14 on page 254
IN
POS
is the voltage on the selected input pin and V
is the voltage on the positive input pin, V
and
shows the resulting output codes if the differential input channel pair
ADC
Table 21-4 on page
shows the decoding of the differential input range.
=
(
----------------------------------------------------------------------- -
V
ADC
POS
REF
the selected voltage reference. The result is presented
–
=
V
NEG
V
--------------------------
V
IN
REF
V
) GAIN 512
⋅
REF
⋅
1024
256). 0x000 represents analog ground, and
NEG
REF
⋅
the voltage on the negative input pin,
the selected voltage reference (see
ATmega1284P
REF
.
253