ATmega1284RZAP Atmel Corporation, ATmega1284RZAP Datasheet - Page 35

• Manufacturer Part Number: ATmega1284RZAP
• Manufacturer: Atmel Corporation

Specifications of ATmega1284RZAP

• Flash (kbytes): 128 Kbytes
• Max. Operating Frequency: 20 MHz
• Max I/o Pins: 32
• Spi: 3
• Twi (i2c): 1
• Uart: 2
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 15
• Analog Comparators: 1
• Crypto Engine: No
• Sram (kbytes): 16
• Eeprom (bytes): 4096
• Operating Voltage (vcc): 1.8 to 3.6
• Timers: 3
• Frequency Band: 2.4 GHz
• Max Data Rate (mb/s): 0.25
• Antenna Diversity: No
• External Pa Control: No
• Power Output (dbm): 3
• Receiver Sensitivity (dbm): -101
• Receive Current Consumption (ma): 16.0
• Transmit Current Consumption (ma): 17.0
• Link Budget (dbm): 104

7.7
7.8
8059D–AVR–11/09
128 kHz Internal Oscillator
External Clock
The 128 kHz internal Oscillator is a low power Oscillator providing a clock of 128 kHz. The fre-
quency is nominal at 3V and 25°C. This clock may be select as the system clock by
programming the CKSEL Fuses to “0011” as shown in
Table 7-13.
Note:
When this clock source is selected, start-up times are determined by the SUT Fuses as shown in
Table
Table 7-14.
To drive the device from an external clock source, XTAL1 should be driven as shown in
7-4. To run the device on an external clock, the CKSEL Fuses must be programmed to “0000”.
Figure 7-4.
When this clock source is selected, start-up times are determined by the SUT Fuses as shown in
Table
Table 7-15.
BOD enabled
Fast rising power
Slowly rising power
Power Conditions
7-14.
7-16.
1. The frequency is preliminary value. Actual value is TBD.
128 kHz Internal Oscillator Operating Modes
Start-up Times for the 128 kHz Internal Oscillator
External Clock Drive Configuration
Crystal Oscillator Clock Frequency
Nominal Frequency
Nominal Frequency
0 - 20 kHz
EXTERNAL
128 kHz
SIGNAL
CLOCK
Start-up Time from Power-
down and Power-save
NC
Reserved
6 CK
6 CK
6 CK
XTAL2
XTAL1
GND
Table
Additional Delay from
7-13.
14CK + 64 ms
14CK + 4 ms
ATmega1284P
Reset
14CK
CKSEL3..0
CKSEL3..0
0011
0000
SUT1..0
00
01
10
11
Figure
35