ATtiny2313 Atmel Corporation, ATtiny2313 Datasheet - Page 22

• Manufacturer Part Number: ATtiny2313
• Manufacturer: Atmel Corporation

Specifications of ATtiny2313

• Flash (kbytes): 2 Kbytes
• Pin Count: 20
• Max. Operating Frequency: 20 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 4
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 18
• Ext Interrupts: 18
• Usb Speed: No
• Usb Interface: No
• Spi: 2
• Twi (i2c): 1
• Uart: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Speed (ksps): 15
• Analog Comparators: 1
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 0.12
• Eeprom (bytes): 128
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8 to 5.5
• Operating Voltage (vcc): 1.8 to 5.5
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 2
• Output Compare Channels: 4
• Input Capture Channels: 1
• Pwm Channels: 4
• 32khz Rtc: No
• Calibrated Rc Oscillator: Yes

System Clock
and Clock
Options
Clock Systems
and their
Distribution
CPU Clock – clk
I/O Clock – clk
Flash Clock – clk
22
ATtiny2313
I/O
CPU
FLASH
Figure 11
need not be active at a given time. In order to reduce power consumption, the clocks to modules
not being used can be halted by using different sleep modes, as described in
ment and Sleep Modes” on page
Figure 11. Clock Distribution
The CPU clock is routed to parts of the system concerned with operation of the AVR core.
Examples of such modules are the General Purpose Register File, the Status Register and the
data memory holding the Stack Pointer. Halting the CPU clock inhibits the core from performing
general operations and calculations.
The I/O clock is used by the majority of the I/O modules, like Timer/Counters, and USART. The
I/O clock is also used by the External Interrupt module, but note that some external interrupts
are detected by asynchronous logic, allowing such interrupts to be detected even if the I/O clock
is halted. Also note that start condition detection in the USI module is carried out asynchronously
when clk
The Flash clock controls operation of the Flash interface. The Flash clock is usually active simul-
taneously with the CPU clock.
I/O
presents the principal clock systems in the AVR and their distribution. All of the clocks
is halted, enabling USI start condition detection in all sleep modes.
General I/O
Modules
External Clock
clk
I/O
Control Unit
AVR Clock
Multiplexer
30. The clock systems are detailed below.
Clock
Source clock
Oscillator
Crystal
CPU Core
clk
clk
Reset Logic
CPU
FLASH
Watchdog clock
Watchdog Timer
RAM
Watchdog
Oscillator
Calibrated RC
Flash and
EEPROM
Oscillator
“Power Manage-
2543L–AVR–08/10