TDA8954 NXP Semiconductors, TDA8954 Datasheet - Page 7

no-image

TDA8954

Manufacturer Part Number
TDA8954
Description
The TDA8954 is a stereo or mono high–efficiency Class D audio power amplifier in asingle IC featuring low power dissipation
Manufacturer
NXP Semiconductors
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
TDA8954J
Manufacturer:
PHI
Quantity:
1 831
Part Number:
TDA8954J
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Part Number:
TDA8954J/N1
Manufacturer:
ENE
Quantity:
439
Part Number:
TDA8954J/N1
Manufacturer:
NXP
Quantity:
14 309
Part Number:
TDA8954J/N1,112
Manufacturer:
NXP
Quantity:
7 322
Part Number:
TDA8954J/N1112
Manufacturer:
NXP Semiconductors
Quantity:
135
Part Number:
TDA8954TH
Manufacturer:
NXP
Quantity:
15 000
Part Number:
TDA8954TH
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Company:
Part Number:
TDA8954TH
Quantity:
10 000
Part Number:
TDA8954TH/N1
0
NXP Semiconductors
TDA8954_1
Product data sheet
The smooth transition between Mute and Operating modes causes a gradual increase in
the DC offset output voltage, which becomes inaudible (no pop noise because the DC
offset voltage rises smoothly). An overview of the start-up timing is provided in
For proper switch-off, the MODE pin should be forced LOW at least 100 ms before the
supply lines (V
Fig 5.
(1) First
2.2 V < V
2.2 V < V
Upper diagram: When switching from Standby to Mute, there is a delay of approximately 100 ms
before the output starts switching. The audio signal will become available once V
Operating mode level (see
pop noise-free, it is recommended that the time constant applied to pin MODE be at least 350 ms
for the transition between Mute and Operating modes.
Lower diagram: When switching directly from Standby to Operating mode, there is a delay of
100 ms before the outputs start switching. The audio signal becomes available after a second
delay of 50 ms. To start-up pop noise-free, it is recommended that the time-constant applied to pin
MODE be at least 500 ms for the transition between Standby and Operating modes.
Timing on mode selection input pin MODE
1
4
DD
MODE
MODE
0 V (SGND)
0 V (SGND)
pulse down.
and V
> 4.2 V
> 4.2 V
V
V
MODE
< 3 V
MODE
< 3 V
Rev. 01 — 24 December 2009
SS
) drop below 12.5 V.
standby
standby
Table
9), but not earlier than 150 ms after switching to Mute. To start-up
duty cycle
duty cycle
100 ms
100 ms
50 %
50 %
mute
mute
(1)
(1)
50 ms
50 ms
2 × 210 W class-D power amplifier
modulated PWM
modulated PWM
audio output
audio output
operating
operating
> 350 ms
> 350 ms
TDA8954
© NXP B.V. 2009. All rights reserved.
MODE
001aah657
time
time
reaches the
Figure
7 of 46
5.

Related parts for TDA8954