LPC2468 NXP Semiconductors, LPC2468 Datasheet - Page 25

• Manufacturer Part Number: LPC2468
• Description: NXP Semiconductors designed the LPC2468 microcontroller around a 16-bit/32-bitARM7TDMI-S CPU core with real-time debug interfaces that include both JTAG andembedded trace
• Manufacturer: NXP Semiconductors

NXP Semiconductors
LPC2468
Product data sheet
7.2 On-chip flash programming memory
7.3 On-chip SRAM
7.4 Memory map
The Thumb set’s 16-bit instruction length allows it to approach higher density compared to
standard ARM code while retaining most of the ARM’s performance.
The LPC2468 incorporates 512 kB flash memory system. This memory may be used for
both code and data storage. Programming of the flash memory may be accomplished in
several ways. It may be programmed In System via the serial port (UART0). The
application program may also erase and/or program the flash while the application is
running, allowing a great degree of flexibility for data storage field and firmware upgrades.
The flash memory is 128 bits wide and includes pre-fetching and buffering techniques to
allow it to operate at speeds of 72 MHz.
The LPC2468 includes a SRAM memory of 64 kB reserved for the ARM processor
exclusive use. This RAM may be used for code and/or data storage and may be accessed
as 8 bits, 16 bits, and 32 bits.
A 16 kB SRAM block serving as a buffer for the Ethernet controller and a 16 kB SRAM
associated with the second AHB can be used both for data and code storage. The 2 kB
RTC SRAM can be used for data storage only. The RTC SRAM is battery powered and
retains the content in the absence of the main power supply.
The LPC2468 memory map incorporates several distinct regions as shown in
Figure
In addition, the CPU interrupt vectors may be remapped to allow them to reside in either
flash memory (default), boot ROM or SRAM (see
Table 5.
Address range General use
0x0000 0000 to
0x3FFF FFFF
0x4000 0000 to
0x7FFF FFFF
4.
LPC2468 memory usage and details
All information provided in this document is subject to legal disclaimers.
on-chip
non-volatile
memory and Fast
I/O
on-chip RAM
Rev. 6.1 — 6 September 2011
Address range details and description
0x0000 0000 - 0x0007 FFFF
0x3FFF C000 - 0x3FFF FFFF
0x4000 0000 - 0x4000 FFFF
0x7FE0 0000 - 0x7FE0 3FFF
0x7FD0 0000 - 0x7FD0 3FFF
Section
Single-chip 16-bit/32-bit micro
7.26.6).
RAM (64 kB)
USB RAM (16 kB)
flash memory (512 kB)
fast GPIO registers
Ethernet RAM (16 kB)
LPC2468
© NXP B.V. 2011. All rights reserved.
Table 5
25 of 85
and