STM32F101VD STMicroelectronics, STM32F101VD Datasheet - Page 19

• Manufacturer Part Number: STM32F101VD
• Description: Mainstream Access line, ARM Cortex-M3 MCU with 384 Kbytes Flash, 36 MHz CPU
• Manufacturer: STMicroelectronics

Specifications of STM32F101VD

• Core: ARM 32-bit Cortex™-M3 CPU
• Conversion Range: 0 to 3.6 V
• Peripherals Supported: timers, ADC, DAC, SPIs, I2Cs and USARTs
• Systick Timer: a 24-bit downcounter

STM32F101xC, STM32F101xD, STM32F101xE
Table 4.
General-purpose timers (TIMx)
There are up to 4 synchronizable general-purpose timers (TIM2, TIM3, TIM4 and TIM5)
embedded in the STM32F101xC, STM32F101xD and STM32F101xE access line devices.
These timers are based on a 16-bit auto-reload up/down counter, a 16-bit prescaler and
feature 4 independent channels each for input capture/output compare, PWM or one-pulse
mode output. This gives up to 16 input captures / output compares / PWMs on the largest
packages.
The general-purpose timers can work together with the advanced-control timer via the Timer
Link feature for synchronization or event chaining. Their counter can be frozen in debug
mode. Any of the general-purpose timers can be used to generate PWM outputs. They all
have independent DMA request generation.
These timers are capable of handling quadrature (incremental) encoder signals and the
digital outputs from 1 to 3 hall-effect sensors.
Basic timers TIM6 and TIM7
These timers are mainly used for DAC trigger generation. They can also be used as a
generic 16-bit time base.
Independent watchdog
The independent watchdog is based on a 12-bit downcounter and 8-bit prescaler. It is
clocked from an independent 40 kHz internal RC and as it operates independently from the
main clock, it can operate in Stop and Standby modes. It can be used either as a watchdog
to reset the device when a problem occurs, or as a free running timer for application timeout
management. It is hardware or software configurable through the option bytes. The counter
can be frozen in debug mode.
Window watchdog
The window watchdog is based on a 7-bit downcounter that can be set as free running. It
can be used as a watchdog to reset the device when a problem occurs. It is clocked from the
main clock. It has an early warning interrupt capability and the counter can be frozen in
debug mode.
Timer
TIM2,
TIM3,
TIM4,
TIM6,
TIM5
TIM7
resolution
Counter
16-bit
16-bit
Timer feature comparison
Counter
up/down
down,
type
Up,
Up
Doc ID 14610 Rev 8
Any integer
Any integer
and 65536
and 65536
between 1
between 1
Prescaler
factor
DMA request
generation
Yes
Yes
Capture/compare
channels
4
0
Complementary
Description
outputs
No
No
19/112