1-1627040-1

Manufacturer Part Number1-1627040-1
ManufacturerTE Connectivity
1-1627040-1 datasheets
 


Specifications of 1-1627040-1

Terminal ShapeRing TongueReceptacle StyleStraight
Barrel TypeOpen BarrelWire/cable TypeRegular Wire
InsulationNoInsulation SupportInsulation Support
Insulation Diameter (mm [in])2.30-3.20 [.091-.126]Stud Diameter (mm [in])6.35 [0.250]
Stud SizeNoneShapeRING-001
Heavy DutyNoFinishNone
Wire Range (mm [awg])0.50-1.50² [20-15]Stock Thickness (mm [in])0.69 [0.027]
Government/industry QualificationNoRohs/elv ComplianceRoHS compliant, ELV compliant
Lead Free Solder ProcessesNot relevant for lead free processRohs/elv Compliance HistoryAlways was RoHS compliant
Packaging MethodStripPackaging Quantity5,000/Reel
Page 1/1

Download datasheet (33Kb)Embed
Product
Specification
Crimping Extruded Ring Terminals
1.
SCOPE
This specification covers the crimp requirements for extruded ring terminals.
2.
CRIMP REQUIREMENTS
2.1.
Figure 1 illustrates the various features defined in the following paragraphs.
2.2.
Tab on back end of terminals shall be .020 maximum.
2.3.
Bellmouth at back of wire barrel shall be .005 to .030.
2.4.
Wire shall lay flat and must extend through wire barrel with no more than 3/64 inch maximum overhang.
2.5.
Crimp heights and crimp width of the wire barrel and crimp width of the insulation barrel are shown in
the following table:
TE PN
40894
©2011 Tyco Electronics Corporation,
| Indicates Change
a TE Connectivity Ltd. Company
*Trademark
All Rights Reserved
TE logo is a trademark.
Figure 1
Wire Barrel
Crimp
Wire Size
Height ±
Crimp Width
.002
18
.056
.110 “F”
20
.053
Table 1
For latest revision, visit out website at www.te.com/documents
For Regional Customer service, visit our website at www.te.com
Other products, logos, and company names might be trademarks of their respective owners.
108-16001
11 Mar 11 Rev A
Insulation
Barrel
Crimp Width
.140 “F”
1 of 1
LOC B