MAX4437 Maxim, MAX4437 Datasheet
MAX4437
Available stocks
Related parts for MAX4437
MAX4437 Summary of contents
Page 1
... The MAX4435/MAX4437 are compen- sated for closed-loop gains greater and have a small-signal, -3dB bandwidth of 150MHz. The MAX4434–MAX4437 op amps require only 15mA of supply current per amplifier while achieving 115dB open-loop gain. Voltage noise density is a low 2.2nV/√Hz and provides 97dB spurious-free dynamic range (SFDR) at 1MHz ...
Page 2
... SOT23 (derate 7.1mW/°C above +70°C) ..........571mW Note 1: The MAX4434–MAX4437 are not protected for output short-circuit conditions. Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied ...
Page 3
... VCL step OUT MAX4434/MAX4436 step OUT MAX4435/MAX4437 (A = +5) VCL step OUT MAX4434/MAX4436 step OUT MAX4435/MAX4437 (A = +5) VCL V = 1.5V to 3.5V step OUT MAX4434/MAX4436 V = 1.5V to 3.5V step OUT MAX4435/MAX4437 (A = +5) VCL step OUT MAX4434/MAX4436 5pF load, C charged from ...
Page 4
... 100kHz V = 4Vp-p C OUT centered 1MHz 100kHz 100kHz 1MHz 1MHz, MAX4436/MAX4437 C Typical Operating Characteristics = +25°C, unless otherwise noted.) A MAX4435/MAX4437 SMALL-SIGNAL GAIN vs. FREQUENCY (A = +5V/V) VCL 3 20mVp 100k 1M 10M 100M FREQUENCY (Hz) ...
Page 5
... LARGE-SIGNAL PULSE RESPONSE A VCL INPUT 1V/div OUTPUT 1V/div 20ns/div MAX4435/MAX4437 GAIN FLATNESS vs. FREQUENCY (A = +5V/V) VCL MAX4434-37 toc05 0.3 4Vp-p 0.2 0.1 0 -0.1 -0.2 -0.3 -0.4 -0.5 -0.6 -0.7 100k 1M 1G FREQUENCY (Hz) MAX4434/MAX4436 SMALL-SIGNAL PULSE RESPONSE INPUT 50mV/div OUTPUT 50mV/div 100M 20ns/div MAX4435/MAX4437 LARGE-SIGNAL PULSE RESPONSE = +1V/V INPUT 200mV/div OUTPUT 1V/div 20ns/div 10M 100M A = +1V/V VCL A = +5V/V VCL 5 ...
Page 6
... OUTPUT ISOLATION RESISTANCE vs. CAPACITIVE LOAD 12 10 MAX4434/MAX4436 8 6 MAX4435/MAX4437 100 150 CAPACITIVE LOAD (pF) 6 _______________________________________________________________________________________ Typical Operating Characteristics (continued) = +25°C, unless otherwise noted.) A MAX4435/MAX4437 SMALL-SIGNAL PULSE RESPONSE A = +5V 15pF L INPUT 10mV/div OUTPUT 50mV/div 20ns/div POWER-SUPPLY REJECTION RATIO vs. FREQUENCY -10 -30 -50 -70 -90 -110 ...
Page 7
... TEMPERATURE (°C) HARMONIC DISTORTION vs. RESISTIVE LOAD 1Vp-p OUT - 500kHz -20 -30 -40 -50 -60 -70 -80 2ND HARMONIC -90 -100 3RD HARMONIC -110 0 500 1000 1500 3.5 4.0 RESISTIVE LOAD (Ω) MAX4436/MAX4437 CROSSTALK vs. FREQUENCY 0 -20 -40 -60 -80 -100 -120 100k 1M 0 FREQUENCY (MHz) OFFSET VOLTAGE vs. TEMPERATURE 1.0 0.8 0.6 0.4 0.2 0 -0.2 -0.4 -0.6 -0.8 -1.0 75 ...
Page 8
... FROM NEGATIVE 30 0 -50 - TEMPERATURE (°C) PIN MAX4434/MAX4435 SOT23 — PIN MAX4436/MAX4437 SO/µMAX _______________________________________________________________________________________ Typical Operating Characteristics (continued) = +25°C, unless otherwise noted 100 NAME OUT Output V Ground EE IN+ Noninverting Input ...
Page 9
... F S Figure 2a. Noninverting Configuration _______________________________________________________________________________________ Ultra-Low Distortion Op Amps and 5 for the MAX4435/MAX4437. Use care in selecting the value for the resistor marked R dynamic stability considerations (based on the part’s fre- quency response and the input capacitance of the MAX4434–MAX4437), the maximum recommended ...
Page 10
... IC pins as possible. Driving Capacitive Loads The MAX4434–MAX4437 can drive capacitive loads. However, excessive capacitive loads may cause ring- ing or instability at the output as phase margin is reduced. Adding a small isolation resistor in series with ...
Page 11
... Single-Supply, 150MHz, 16-Bit Accurate, (For the latest package outline information and land patterns www.maxim-ic.com/packages.) PACKAGE TYPE 5 SOT23 µMAX ______________________________________________________________________________________ Ultra-Low Distortion Op Amps PACKAGE CODE U5-1 S8-2 U8-1 Package Information DOCUMENT NO. 21-0057 21-0036 21-0041 11 ...
Page 12
... Single-Supply, 150MHz, 16-Bit Accurate, Ultra-Low Distortion Op Amps (For the latest package outline information and land patterns www.maxim-ic.com/packages.) 12 ______________________________________________________________________________________ Package Information (continued) α α ...
Page 13
... Single-Supply, 150MHz, 16-Bit Accurate, (For the latest package outline information and land patterns www.maxim-ic.com/packages TOP VIEW FRONT VIEW ______________________________________________________________________________________ Ultra-Low Distortion Op Amps Package Information (continued 0∞-8∞ L SIDE VIEW INCHES MILLIMETERS DIM MIN MAX ...
Page 14
... Added automotive part number Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. 14 ____________________Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600 © ...