MAX9108 Maxim, MAX9108 Datasheet
MAX9108
Available stocks
Related parts for MAX9108
MAX9108 Summary of contents
Page 1
... The dual MAX9107 is available in both 8-pin SO and SOT23 packages. The quad MAX9108 is available in 14-pin TSSOP and SO packages while the single MAX9109 is available in an ultra-small 6-pin SC70 package, a space-saving 6-pin SOT23 package and an 8-pin SO package ...
Page 2
... SOT23 (derate 8.7mW/°C above +70°C)696mW Stresses beyond those listed under “Absolute Maximum Ratings" may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability ...
Page 3
... Note 5: Tested over the full-input voltage range (V Note 6: Differential Propagation Delay is specified as the difference between any two channels in the MAX9107/MAX9108 (both outputs making either a low-to-high or a high-to-low transition). Note 7: Propagation Delay Skew is specified as the difference between any single channel’s output low-to-high transition (t ...
Page 4
Dual/Quad/Single, Low-Power, TTL Comparators __________________________________________Typical Operating Characteristics ( 15pF +25°C, unless otherwise noted SUPPLY CURRENT vs. SUPPLY VOLTAGE (OUTPUTS 0 ...
Page 5
Dual/Quad/Single, Low-Power, ____________________________Typical Operating Characteristics (continued 5V 15pF +25°C, unless otherwise noted PROPAGATION DELAY (t INPUT 50mV/div OVERDRIVE 10mV OUTPUT 1V/div 10ns/div SINUSOID 2MHz RESPONSE INPUT ...
Page 6
... Noise or undesired parasitic AC feedback cause most high-speed comparators to oscillate in the linear region (i.e., when the voltage on one input near the voltage on the other input). The MAX9107/MAX9108/ MAX9109 eliminate this problem by incorporating an internal hysteresis of 2mV. When the two comparator input voltages are equal, hysteresis effectively causes ...
Page 7
... Solder the device directly to the printed circuit board instead of using a socket. Overdriving the Inputs The inputs to the MAX9107/MAX9108/MAX9109 may be driven beyond the voltage limits given in the Absolute Maximum Ratings, as long as the current flowing into the device is limited to 25mA. However, if the inputs are over- driven, the output may be inverted ...
Page 8
... Dual/Quad/Single, Low-Power, TTL Comparators Chip Information MAX9107 TRANSISTOR COUNT: 262 MAX9108 TRANSISTOR COUNT: 536 MAX9109 TRANSISTOR COUNT: 140 PROCESS: Bipolar (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information go to www.maxim-ic.com/packages.) ...
Page 9
... Dual/Quad/Single, Low-Power, (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information go to www.maxim-ic.com/packages.) _______________________________________________________________________________________ TTL Comparators Package Information (continued) 9 ...
Page 10
... Dual/Quad/Single, Low-Power, TTL Comparators (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information go to www.maxim-ic.com/packages.) 10 ______________________________________________________________________________________ Package Information (continued) PACKAGE OUTLINE, 6L SC70 21-0077 ...
Page 11
... Dual/Quad/Single, Low-Power, (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information go to www.maxim-ic.com/packages.) ______________________________________________________________________________________ TTL Comparators Package Information (continued) 11 ...
Page 12
... Dual/Quad/Single, Low-Power, TTL Comparators (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information go to www.maxim-ic.com/packages.) 12 ______________________________________________________________________________________ Package Information (continued) ...
Page 13
... Revision History Pages revised at Rev 9–13 Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. ...