PM5381-BI PMC-Sierra, Inc., PM5381-BI Datasheet - Page 342

• Manufacturer Part Number: PM5381-BI
• Description: ATM UNI, Single Channel ATM PHY Interface for 2488.32Mbps
• Manufacturer: PMC-Sierra, Inc.

Proprietary and Confidential to PMC-Sierra, Inc., and for its Customers’ Internal Use
Document ID: PMC-2000489, Issue 4
LAISEN
LRDIEN
APSBFEN
STIUEN
STIMEN
SDBEREN
The LAIS enable bit allows the line alarm indication signal defect to be OR’ed into the
SALM output. When the LAISEN bit is set high, the corresponding defect indication is
ORed with other defect indications and output on SALM. When the LAISEN bit is set low,
the corresponding defect indication does not affect the SALM output.
The LRDI enable bit allows the line remote defect indication defect to be OR’ed into the
SALM output. When the LRDIEN bit is set high, the corresponding defect indication is
OR’ed with other defect indications and output on SALM. When the LRDIEN bit is set low,
the corresponding defect indication does not affect the SALM output.
The APSBF enable bit allows the APS byte failure defect to be OR’ed into the SALM output.
When the APSBFEN bit is set high, the corresponding defect indication is OR’ed with other
defect indications and output on SALM. When the APSBFEN bit is set low, the
corresponding defect indication does not affect the SALM output.
The STIU enable bit allows the section trace identifier unstable defect to be OR’ed into the
SALM output. When the STIUEN bit is set high, the corresponding defect indication is
OR’ed with other defect indications and output on SALM. When the STIUEN bit is set low,
the corresponding defect indication does not affect the SALM output.
The STIM enable bit allows the section trace identifier mismatch defect to be OR’ed into the
SALM output. When the STIMEN bit is set high, the corresponding defect indication is
OR’ed with other defect indications and output on SALM. When the STIMEN bit is set low,
the corresponding defect indication does not affect the SALM output.
The SDBER enable bit allows the signal degrade BER defect to be OR’ed into the SALM
output. When the SDBEREN bit is set high, the corresponding defect indication is OR’ed
with other defect indications and output on SALM. When the SDBEREN bit is set low, the
corresponding defect indication does not affect the SALM output.
S/UNI-2488 Telecom Standard Product Datasheet
Released
342