HT-CM400 NXP Semiconductors, HT-CM400 Datasheet - Page 44

• Manufacturer Part Number: HT-CM400
• Description: Ht Cm400; Ht Rm440 Family; Ht Rm800 Family Interface Protocol Reader - Host
• Manufacturer: NXP Semiconductors

Communication Reader-Host
3.7.27 Reset
This command resets basic functions of the read/write device. All port-pins of the HITAG
Communication Controller are reset to an initial state (output pins are set to ‘0’, input pins are set
to ‘1’).
You should not interrupt the Permanent Reading Mode (activated after ReadMiro, ReadPit, ...)
or the permanent writing mode (e.g. activated after WritePit) of the read/write device by invoking
this command, since Reset can cause undesirable side effects (resetting output pins). Use
StopCommand instead.
C-Function: void proloc_Reset (void);
Header-File: PROLIB6.H
Serial protocol:
HOST - READ/WRITE DEVICE
READ/WRITE DEVICE - HOST
Status:
Htswp.doc/HS
0x02
0x02
Status
'R'
-1 ...
0 ... no error
0x50
BCC
SERIAL ERROR
Page 44 (104)
Rev. 1.0
98-02-10