MB3887 Fujitsu, MB3887 Datasheet - Page 17

• Manufacturer Part Number: MB3887
• Description: DC/DC Converter IC
• Manufacturer: Fujitsu

CTL function table
2. Protection Functions
Under voltage lockout protection circuit (UVLO)
Protection circuit (UVLO) operation function table
(7) PWM comparator block (PWM Comp.)
(8) Output block (OUT)
(9) Control block (CTL)
(10) Bias voltage block (VH)
The PWM comparator circuit is a voltage-pulse width converter for controlling the output duty of the error
amplifiers (Error Amp1 to Error Amp3) depending on their output voltage.
The PWM comparator circuit compares the triangular wave generated by the triangular wave oscillator to the
error amplifier output voltage and turns on the external output transistor during the interval in which the triangular
wave voltage is lower than the error amplifier output voltage.
The output circuit uses a totem-pole configuration capable of driving an external P-channel MOS FET.
The output “L” level sets the output amplitude to 6 V (Typ) using the voltage generated by the bias voltage block
(VH) .
This results in increasing conversion efficiency and suppressing the withstand voltage of the connected external
transistor in a wide range of input voltages.
Setting the CTL terminal (pin 14) low places the IC in the standby mode. (The supply current is 10 µA at maximum
in the standby mode.)
The bias voltage circuit outputs V
mode, this circuit outputs the potential equal to VCC.
The transient state or a momentary decrease in supply voltage or internal reference voltage (VREF) , which
occurs when the power supply (VCC) is turned on, may cause malfunctions in the control IC, resulting in
breakdown or degradation of the system.
To prevent such malfunction, the under voltage lockout protection circuit detects a supply voltage or internal
reference voltage drop and fixes the OUT terminal (pin 20) to the “H” level. The system restores voltage supply
when the supply voltage or internal reference voltage reaches the threshold voltage of the under voltage lockout
protection circuit.
When UVLO is operating (VCC or VREF voltage is lower than UVLO threshold voltage.)
OUTD
CTL
Hi-Z
H
L
CC
−6 V (Typ) as the minimum potential of the output circuit. In the standby
OFF (Standby)
ON (Active)
Power
OUT
H
OUTD
Hi-Z
CS
L
L
MB3887
17