CMPS03 ETC, CMPS03 Datasheet

CMPS03

Manufacturer Part Number

CMPS03

Description

CMPS03 - Robot Compass Module

Manufacturer

ETC

Datasheet

1.CMPS03.pdf (3 pages)

Current page: 1 of 3
Download datasheet (106Kb)

CMPS03 - Robot Compass Module

This compass module has been specifically designed for use in robots as an aid to navigation. The aim was to produce a unique number to

represent the direction the robot is facing. The compass uses the Philips KMZ51 magnetic field sensor, which is sensitive enough to detect the

Earths magnetic field. The output from two of them mounted at right angles to each other is used to compute the direction of the horizontal

component of the Earths magnetic field.

Connections to the compass module

The compass module requires a 5v power supply at a nominal 15mA.

There are two ways of getting the bearing from the module. A PWM signal is available on pin 4, or an I2C interface is provided on pins 2,3.

The PWM signal is a pulse width modulated signal with the positive width of the pulse representing the angle. The pulse width varies from

1mS (0° ) to 36.99mS (359.9° ) – in other words 100uS/° with a +1mS offset. The signal goes low for 65mS between pulses, so the cycle time

is 65mS + the pulse width - ie. 66ms-102ms. The pulse is generated by a 16 bit timer in the processor giving a 1uS resolution, however I

would not recommend measuring this to anything better than 0.1° (10uS). Make sure you connect the I2C pins, SCL and SDA, to the 5v

supply if you are using the PWM, as there are no pull-up resistors on these pins.

Pin 2,3 are an I2C interface and can be used to get a direct readout of the bearing. If the I2C interface is not used then these pins should be

pulled high (to +5v) via a couple of resistors. Around 47k is ok, the values are not at all critical.

Related parts for CMPS03

CMPS03 Summary of contents

Page 1

... CMPS03 - Robot Compass Module This compass module has been specifically designed for use in robots as an aid to navigation. The aim was to produce a unique number to represent the direction the robot is facing. The compass uses the Philips KMZ51 magnetic field sensor, which is sensitive enough to detect the Earths magnetic field ...

Page 2

I2C communication protocol with the compass module is the same as popular eeprom's such as the 24C04.. First send a start bit, the module address (0XC0) with the read/write bit low, then the register number you wish to read. This ...

Page 3

The I2C interface does not have any pull-up resistors on the board, these should be provided elsewhere, most probably with the bus master. They are required on both the SCL and SDA lines, but only once for the whole bus, ...

Related keywords

CMPS03 datasheet
CMPS03 data sheet
CMPS03 pdf datasheet
CMPS03 component
CMPS03 part
CMPS03 distributor
CMPS03 RoHS
CMPS03 datasheet download