LM190E08-TLL1 LG, LM190E08-TLL1 Datasheet - Page 28

• Manufacturer Part Number: LM190E08-TLL1
• Description: TFT LCD Module
• Manufacturer: LG

9-1. MOUNTING PRECAUTIONS
9-2. OPERATING PRECAUTIONS
9. PRECAUTIONS
Please pay attention to the followings when you use this TFT LCD module.
(1) You must mount a module using holes arranged in four corners or four sides.
(2) You should consider the mounting structure so that uneven force (ex. Twisted stress) is
(3) Please attach the surface transparent protective plate to the surface in order to protect
(4) You should adopt radiation structure to satisfy the temperature specification.
(5) Acetic acid type and chlorine type materials for the cover case are not desirable because
(6) Do not touch, push or rub the exposed polarizers with glass, tweezers or anything harder
(7) When the surface becomes dusty, please wipe gently with absorbent cotton or other soft
(8) Wipe off saliva or water drops as soon as possible. Their long time contact with polarizer
(9) Do not open the case because inside circuits do not have sufficient strength.
(1) The spike noise causes the mis-operation of circuits. It should be lower than following
(2) Response time depends on the temperature.(In lower temperature, it becomes longer.)
(3) Brightness depends on the temperature. (In lower temperature, it becomes lower.)
(4) Be careful for condensation at sudden temperature change. Condensation makes damage
(5) When fixed patterns are displayed for a long time, remnant image is likely to occur.
(6) Module has high frequency circuits. Sufficient suppression to the electromagnetic
(7) Please do not give any mechanical and/or acoustical impact to LCM. Otherwise, LCM can
(8) A screw which is fastened up the steels should be a machine screw (if not, it causes metal
(9) Please do not set LCD on its edge.
Ver. 0.1
(Some cosmetics are detrimental to the polarizer.)
not applied to the Module. And the case on which a module is mounted should have
sufficient strength so that external force is not transmitted directly to the module.
the polarizer. Transparent protective plate should have sufficient strength in order to the
resist external force.
the former generates corrosive gas of attacking the polarizer at high temperature and the
latter causes circuit break by electro-chemical reaction.
than HB pencil lead. And please do not rub with dust clothes with chemical treatment.
Do not touch the surface of polarizer for bare hand or greasy cloth.
materials like chamois soaks with petroleum benzene. Normal-hexane is recommended
for cleaning the adhesives used to attach front / rear polarizers. Do not use acetone,
toluene and alcohol because they cause chemical damage to the polarizer.
causes deformations and color fading.
voltage : V=±200mV(Over and under shoot voltage)
And in lower temperature, response time(required time that brightness is stable after
turned on) becomes longer.
to polarizer or electrical contacted parts. And after fading condensation, smear or spot will
occur.
foreign material and deal LCM a fatal blow)
interference shall be done by system manufacturers. Grounding and shielding methods
may be important to minimized the interference.
not be operated its full characteristics perfectly.
Product Specification
Nov., 15, 2006
www.DataSheet.net/
Liquid Crystal Display
28 / 29
Datasheet pdf - http://www.DataSheet4U.co.kr/