MD1050-DCC M-Systems Inc., MD1050-DCC Datasheet - Page 45

• Manufacturer Part Number: MD1050-DCC
• Description: Diskonchip Ide Pro Data Sheet
• Manufacturer: M-Systems Inc.

6.4
If DiskOnChip IDE Pro is being installed as an additional IDE drive using the same IDE I/O port,
jumper J1 must be set to indicate that this drive is a slave. The default is master with no jumpers.
Table 7, Figure 5 and Figure 6 show the J1 jumper settings for DiskOnChip IDE Pro operation in
Master and Slave mode.
44
Installing DiskOnChip IDE Pro in a Two-Drive Configuration
(Master/Slave)
Short pins A to B or C to D
J1 Jumper Settings
Figure 6: Master Settings, 44-pin (left) and 40-pin (right) Connectors
Figure 5: Slave Settings, 44-pin (left) and 40-pin (right) Connectors
Open
Table 7: Jumper Settings for Master/Slave Mode
DiskOnChip IDE Pro Data Sheet, Rev. 1.5
Operation Mode
Master
Slave
91-SR-012-01-8L