AT94K05AL ATMEL Corporation, AT94K05AL Datasheet - Page 132

• Manufacturer Part Number: AT94K05AL
• Description: Fpslic Devices Combine 5K Gates of Atmel's Patented AT40K Fpga Architecture, a 20 Mips Avr 8-bit Risc Microprocessor Core, Numerous Fixed Microcontroller Peripheries And up to 36K Bytes of Program And Data SRAM.
• Manufacturer: ATMEL Corporation

132
AT94K Series FPSLIC
• Bits 7..0 - 2-wire Serial Bit-rate Register
TWBR selects the division factor for the bit-rate generator. The bit-rate generator is a fre-
quency divider which generates the SCL clock frequency in the Master modes according to
the following equation:
•
•
•
Both the receiver and the transmitter can stretch the Low period of the SCL line when waiting
for user response, thereby reducing the average bit rate.
The 2-wire Serial Control Register – TWCR
• Bit 7 - TWINT: 2-wire Serial Interrupt Flag
This bit is set by the hardware when the 2-wire Serial Interface has finished its current job and
expects application software response. If the I-bit in the SREG and TWIE in the TWCR regis-
ter are set (one), the MCU will jump to the interrupt vector at address $0046. While the TWINT
flag is set, the bus SCL clock line Low period is stretched. The TWINT flag must be cleared by
software by writing a logic 1 to it. Note that this flag is not automatically cleared by the hard-
ware when executing the interrupt routine. Also note that clearing this flag starts the operation
of the 2-wire Serial Interface, so all accesses to the 2-wire Serial Address Register – TWAR,
2-wire Serial Status Register – TWSR, and 2-wire Serial Data Register – TWDR must be com-
plete before clearing this flag.
• Bit 6 - TWEA: 2-wire Serial Enable Acknowledge Flag
TWEA flag controls the generation of the acknowledge pulse. If the TWEA bit is set, the ACK
pulse is generated on the 2-wire Serial Bus if the following conditions are met:
•
•
•
By setting the TWEA bit Low the device can be virtually disconnected from the 2-wire Serial
Bus temporarily. Address recognition can then be resumed by setting the TWEA bit again.
• Bit 5 - TWSTA: 2-wire Serial Bus START Condition Flag
The TWSTA flag is set by the CPU when it desires to become a Master on the 2-wire Serial
Bus. The 2-wire serial hardware checks if the bus is available, and generates a Start condition
on the bus if the bus is free. However, if the bus is not free, the 2-wire Serial Interface waits
until a STOP condition is detected, and then generates a new Start condition to claim the bus
Master status.
Bit
$36 ($56)
Read/Write
Initial Value
Bit-rate = SCL frequency
f
TWBR = Contents of the 2-wire Serial Bit Rate Register
The device’s own Slave address has been detected
A general call has been received, while the TWGCE bit in the TWAR is set
A data byte has been received in Master Receiver or Slave Receiver mode
CK
= CPU Clock frequency
Bit-rate
7
TWINT
R/W
0
=
6
TWEA
R/W
0
------------------------------------- -
16 + 2(TWBR)
f
CK
5
TWSTA
R/W
0
4
TWSTO
R/W
0
3
TWWC
R
0
2
TWEN
R/W
0
1
-
R
0
Rev. 1138F–FPSLI–06/02
0
TWIE
R/W
0
TWCR