CP1E-N14DR-A Omron Corporation, CP1E-N14DR-A Datasheet - Page 33

• Manufacturer Part Number: CP1E-N14DR-A
• Description: Sysmac Cp-series Cp1e Cpu Units
• Manufacturer: Omron Corporation

Connecting to Support Software
Operating Environment and System Configuration
The following system is required to operate the CX-Programmer. Make sure your system provides the following conditions and has the necessary
components.
Connecting Methods
Using commercially available USB cable, connect the CX-Programmer to the peripheral USB port on the CPU Unit.
Commercially available
USB cable *
Note: The CX-Programmer cannot be used if it is connected to the built-in RS-232C port or serial option port of a CP1E CPU Unit.
* Commercially available USB cable: 5 m max., for USB 2.0.
Connecting Cable
Use the following cable to connect the CP1E CPU Unit to the computer running the Support Software.
Supported computer
CD-ROM or DVD-ROM drive
Supported Operating Systems
CPU
RAM
Available hard disk space
Display
PLC and connection port
Peripheral USB port
(Conforming to USB 2.0, B connector)
A connector
Item
Port at Unit
CX-Programmer
Peripheral USB port
(Conforming to USB 2.0, B connector)
B connector
IBM PC/AT or equivalent
One or more
Windows 7, Windows Vista, Windows XP,
Windows 2000 (Service Pack 4 or later)
(except 64-bit edition)
Pentium II 333 MHz or faster
256 MB min. 512 MB or more recommended
600 MB min.
800 x 600 SVGA min.
USB port
USB port
Port at computer
CP1E CPU Unit
Description
USB port
CP1E-E@@D@-@ CP1E-N@@D@-@/NA20D@-@
(communications mode)
USB 2.0 (or 1.1)
Network type
Commercially available USB cable
(A connector - B connector)
Model numbers
Less than 5 m
Length
33