DS1007 Dallas Semiconducotr, DS1007 Datasheet - Page 5

no-image

DS1007

Manufacturer Part Number
DS1007
Description
7-1 Silicon Delay Line
Manufacturer
Dallas Semiconducotr
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
DS1007-1
Manufacturer:
DALLAS
Quantity:
6 228
Part Number:
DS1007-3
Manufacturer:
DENSO
Quantity:
6 230
Part Number:
DS1007-6
Manufacturer:
DALLAS
Quantity:
6 219
Part Number:
DS1007-7
Manufacturer:
DALLAS
Quantity:
20 000
Part Number:
DS1007S-002
Manufacturer:
DALLAS
Quantity:
52
Part Number:
DS1007S-1
Manufacturer:
DALLAS
Quantity:
10
Part Number:
DS1007S-1
Manufacturer:
MAXIM/美信
Quantity:
20 000
Part Number:
DS1007S-2
Manufacturer:
MAXIM/美信
Quantity:
20 000
Part Number:
DS1007S-2+
Manufacturer:
DALLAS
Quantity:
20 000
Part Number:
DS1007S-3
Manufacturer:
MAXIM/美信
Quantity:
20 000
NOTES:
1. All voltages are referenced to ground.
2. Measured with outputs open.
3. V
4. See Test Conditions below.
5. All output delays in the same speed output tend to vary unidirectionally with temperature or voltage
6. Period specifications may be exceeded; however, accuracy will be application-sensitive (decoupling,
7. t
TERMINOLOGY
Period: The time elapsed between the leading edge of the first pulse and the leading edge of the
following pulse.
t
1.5V point on the trailing edge, or the 1.5V point on the trailing edge and the 1.5V point on the leading
edge.
t
input pulse.
t
input pulse.
t
pulse and the 1.5V point on the leading edge of the corresponding output pulse.
TEST SETUP DESCRIPTION
Figure 3 illustrates the hardware configuration used for measuring the timing parameters on the DS1007.
The input waveform is produced by a precision pulse generator under software control. Time delays are
measured by a time interval counter (20 ps resolution) connected between the input and each output. Each
output is selected and connected to the counter by a VHF switch control unit. All measurements are fully
automated, with each instrument controlled by a central computer over an IEEE 488 bus.
WI
RISE
FALL
PLH
range (i.e., if Out 2 slows down, all other outputs also slow down).
layout, etc.).
(Pulse Width): The elapsed time on the pulse between the 1.5V point on the leading edge and the
PU
(Time Delay, Rising): The elapsed time between the 1.5V point on the leading edge of the input
(Input Rise Time): The elapsed time between the 20% and the 80% point on the leading edge of the
CC
(Input Fall Time): The elapsed time between the 80% and the 20% point on the trailing edge of the
= 0 ms for Out 1 through Out 4.
= 5V @25 C. Delays accurate on rising edges within 2 ns.
5 of 6
DS1007

Related parts for DS1007