TM121XG_02L10D TORiSAN, TM121XG_02L10D Datasheet - Page 13

• Manufacturer Part Number: TM121XG_02L10D
• Description: LCD_Module
• Manufacturer: TORiSAN

Tottori SANYO Electric Co., Ltd.
1. Instructions for safety
2. Instructions for designing
PRECAUTIONS (INSTRUCTIONS FOR SAFE AND PROPER USE)
(1)
(2)
(3)
(4)
(5)
(6)
(1)
(2)
Please do not disassemble or modify LCD module to avoid the possibility of
electric shock, damage of electronic components, scratch at display surface and
invasion of foreign particles. In addition, such activity may result in fire accident
due to burning of electronic component.
Please be careful in handling of LCD module with broken glass.
When the display glass breaks, please pay attention not to injure your fingers. The
display surface has the plastic film attached, which prevents dispersion of glass
pieces, however touching broken edge will injure your fingers. Also lamp (Cold
Cathode Fluorescent Lamp) is made of glass, therefore please pay attention in the
same way.
Please do not touch the fluid flown out of broken display glass.
If the fluid should stick to hand or clothes, wipe off with soap or alcohol immediately
and then wash it with water. If the fluid should get in eyes, wash eyes immediately
with washing lotion for more than 15 minutes and then consult the doctor.
Please make secure connection of lamp connector.
Please make sure that lamp connector from LCD module is connected w ith output
connector on inverter circuit securely. Poor connection may cause smoke or fire
accident due to high voltage in circuit. If connection may not be secure, please
switch off the power supply for LCD module and lamp and then make secure
connection.
Please do not make connection with another connector than recommended mating
connector.
Lamp contains mercury inside. Please follow regulations or rules established by
local autonomy at its disposal.
Please be careful to electric shock.
Before handling LCD module, please switch off the power supply.
Since high voltage is applied to lamp terminal, cable, connector and inverter circuit
in operation mode, touching them will cause electric shock.
Mounting of LCD
Please fix LCD module at all mounting holes shown in this specification for
installation onto system. The used screws should have proper dimensions.
Furthermore, designing of mounting parts should be adequate so that LCD module
is not putted stresses (ex. warped, twisted and pressed stress), to achieve good
display quality. The stresses may cause non-uniformity even if there is no non-
uniformity statically.
Polarity of power supply for lamp
Please give careful consideration in designing so that each polar of cable should
be connected correctly at assembling (i.e. high voltage side is connected to high
voltage side and low voltage side is connected to low voltage side). Since longer
lamp cable may cause insatiable start-up of lamp and reduction of brightness,
please make cable short as much as possible.
LCD module disassembled or modified by customer is out of warranty.
TM121XG-02L10D
Ver.2
Page
12/16