ad5539jq Analog Devices, Inc., ad5539jq Datasheet - Page 16

• Manufacturer Part Number: ad5539jq
• Description: Ultrahigh Frequency Operational Amplifier
• Manufacturer: Analog Devices, Inc.

AD5539
quency applications including color key switching. It features
both inverting and noninverting inputs and can provide an out-
put of
150 ). An optional output offset adjustment is provided. The
input range of the video switch is the same as the output range:
(inverting) across the 75
about 1, when “ON,” or zero when “OFF.”
The differential configuration uses both channels of the AD539
not only to provide alternative input phases, but also to elimi-
nate the switching pedestal due to step changes in the output
current as the AD539 is gated on or off.
Figure 49 shows the response to a pulse of 0 to +1 V on the
signal channel. With the control input held at zero, the rise
time is under 10 ns. The response from the inverting input
is similar.
1 V at either input generates 1 V (noninverting) or 1 V
Figure 48. The Control Response of the Video Switcher
1 V into a reverse-terminated 75
14-Pin Cerdip Package
load. The circuit provides a gain of
(Q-14)
load (or 2 V into
Dimensions shown in inches and (mm).
OUTLINE DIMENSIONS
–16–
The differential-gain and differential-phase characteristics of
this switch are compatible with video applications. The incre-
mental gain changes less than 0.05 dB over a signal window of 0
to +1 V, with a phase variation of less than 0.5 degree at the
subcarrier frequency of 3.58 MHz. The noise level of this cir-
cuit measured at the 75
to 5 MHz bandwidth or approximately 100 nV per root hertz.
The noise spectral density is essentially flat to 40 MHz.
The waveforms shown in Figures 48 and 49 were taken across a
75
this case, an offset sine wave at 1 MHz) was applied to the
noninverting input. In Figure 48, the envelope response shows
the output being fully switched in about 50 ns. Note that the
output is ON when the control input is zero (or more negative)
and OFF for a control input of +1 V or more. There is very
little control-signal breakthrough.
Figure 49. The Signal Response of the Video Switcher
termination; in both photos, the signal of 0 to +1 V (in
14-Pin Plastic DIP Package
load is typically 200 V in a 0 MHz
(N-14)
REV. B