st62t65b STMicroelectronics, st62t65b Datasheet - Page 28

• Manufacturer Part Number: st62t65b
• Description: 8-bit Otp/eprom Mcus With A/d Converter, Auto-reload Timer, Eeprom And Spi
• Manufacturer: STMicroelectronics

28
ST62T55B ST62T65B/E65B
IINTERRUPTS (Cont’d)
3.4.2 Interrupt Procedure
The interrupt procedure is very similar to a call pro-
cedure, indeed the user can consider the interrupt
as an asynchronous call procedure. As this is an
asynchronous event, the user cannot know the
context and the time at which it occurred. As a re-
sult, the user should save all Data space registers
which may be used within the interrupt routines.
There are separate sets of processor flags for nor-
mal, interrupt and non-maskable interrupt modes,
which are automatically switched and so do not
need to be saved.
The following list summarizes the interrupt proce-
dure:
MCU
– The interrupt is detected.
– The C and Z flags are replaced by the interrupt
– The PC contents are stored in the first level of
– The normal interrupt lines are inhibited (NMI still
– The first internal latch is cleared.
– The associated interrupt vectoris loaded inthe PC.
WARNING: In some circumstances, when a
maskable interrupt occurs while the ST6 core is in
NORMAL mode and especially during the execu-
tion of an ”ldi IOR, 00h” instruction (disabling all
maskable interrupts): if the interrupt arrives during
the first 3 cycles of the ”ldi” instruction (which is a
4-cycle instruction) the core will switch to interrupt
mode BUT the flags CN and ZN will NOT switch to
the interrupt pair CI and ZI.
User
– User selected registers are saved within the in-
– The source of the interrupt is found by polling the
– The interrupt is serviced.
– Return from interrupt (RETI)
28/74
flags (or by the NMI flags).
the stack.
active).
terrupt service routine (normally on a software
stack).
interrupt flags (if more than one source is associ-
ated with the same vector).
MCU
– Automatically the MCU switches back to the nor-
The interrupt routine usually begins by the identify-
ing the device which generated the interrupt re-
quest (by polling). The user should save the regis-
ters which are used within the interrupt routine in a
software stack. After the RETI instruction is exe-
cuted, the MCU returns to the main routine.
Figure 16. Interrupt Processing Flow Chart
mal flag set (or the interrupt flag set) and pops
the previous PC value from the stack.
YES
N O
PR OGRAM FLAGS
THE INS TRUCTI ON
INT ER RU PT MASK
THE STACK ED PC
INS TRUCTIO N
INS TRUC TION
INS TRUCT ION
EXEC UTE
A RE TI
SELECT
WAS
FETC H
C LEAR
”POP”
?
?
YES
N O
YES
?
AN IN TERR UP T RE QUEST
NO
NOR MAL MODE?
AN D INTE RR UPT MASK
IS THE C ORE
ALRE ADY IN
C HE CK IF THE RE IS
IN TERN AL MODE FLAG
PC INTO THE STAC K
INT ERR UP T VECT OR
INT ER RU PT MASK
LOAD PC FROM
PUS H THE
(FFC/F FD)
SELECT
SET
VA000014