st62t65b STMicroelectronics, st62t65b Datasheet - Page 43

• Manufacturer Part Number: st62t65b
• Description: 8-bit Otp/eprom Mcus With A/d Converter, Auto-reload Timer, Eeprom And Spi
• Manufacturer: STMicroelectronics

AUTO-RELOAD TIMER (Cont’d)
It should be noted that the reload values will also
affect the value and the resolution of the duty cycle
of PWM output signal. To obtain a signal on ARTI-
Mout, the contents of the ARCP register must be
greater than the contents of the ARRC register.
The maximum available resolution for the ARTI-
Mout duty cycle is:
Where ARRC is the content of the Reload/Capture
register. The compare value loaded in the Com-
pare Register, ARCP, must be in the range from
(ARRC) to 255.
Figure 24. . Auto-reload Timer PWM Function
PWM OUTPUT
COMPARE
VALUE
REGISTER
COUNTER
RELOAD
Resolution = 1/[255-(ARRC)]
255
000
The ARTC counter is initialized by writing to the
ARRC register and by then setting the TCLD (Tim-
er Load) and the TEN (Timer Clock Enable) bits in
the Mode Control register, ARMC.
Enabling and selection of the clock source is con-
trolled by the CC0, CC1, SL0 and SL1 bits in the
Status Control Register, ARSC1. The prescaler di-
vision ratio is selected by the PS0, PS1 and PS2
bits in the ARSC1 register.
In Auto-reload Mode, any of the three available
clock sources can be selected: Internal Clock, In-
ternal Clock divided by 3 or the clock signal
present on the ARTIMin pin.
ST62T55B ST62T65B/E65B
VR001852
t
t
43/74
43