upc1093 Renesas Electronics Corporation., upc1093 Datasheet
upc1093
Available stocks
Related parts for upc1093
upc1093 Summary of contents
Page 1
ADJUSTABLE PRECISION SHUNT REGULATORS DESCRIPTION The PC1093 are adjustable precision shunt regulators with guaranteed thermal stability. The output voltage can be set to any value between reference voltage (2.495 V) and two external resistors. These ICs can ...
Page 2
EQUIVALENT CIRCUIT R 5 REF PIN CONFIGURATION (Marking Side) 3-pin plastic SIP (TO-92) • PC1093J ...
Page 3
ABSOLUTE MAXIMUM RATING (T Parameter Symbol Cathode Voltage V KA Cathode Current I K Cathode-Anode Reverse Current –I K Reference Voltage V REF Reference Input Current I REF Reference-Anode Reverse Current –I REF Power Dissipation PC1093J P T PC1093G PC1093T ...
Page 4
ELECTRICAL CHARACTERISTICS (T Parameter Symbol Reference Voltage V REF Reference Voltage Deviation Over V REF Temperature Reference Voltage Deviation Over V REF Cathode Voltage Reference Input Current I REF Reference Input Current Deviation I REF Over Temperature Minimum Cathode Current ...
Page 5
TYPICAL CHARACTERISTICS 0.8 PC1093J 180 C/W 0.6 PC1093G 260 C/W 0.4 PC1093T 315 C/W 0.2 PC1093TA 695 C Operating Ambient Temperature - ...
Page 6
REF – -Operating Ambient Temperature - 100 ...
Page 7
STABILITY AREA 100 REF Stable ...
Page 8
PACKAGE DRAWINGS 3 PIN PLASTIC SIP (TO-92 NOTE Each lead centerline is located within 0. its true position (T.P.) at maximum material condition ITEM ...
Page 9
PIN PLASTIC SOP (225 mil NOTE Each lead centerline is located within 0. its true position (T.P.) at maximum material condition. 5 detail of lead end ...
Page 10
POWER MINI MOLD (SOT-89) (Unit: mm) 0.42 0.06 10 4.5 0.1 1.6 0.2 1.5 0.1 0.42 0.06 0.47 1.5 0.06 3.0 0.03 0.41 0.05 PC1093 ...
Page 11
PIN PLASTIC MINI MOLD detail of lead end PC1093 ITEM MILLIMETERS A 2.9 0.2 B 0.3 C 0.95 (T.P.) 0.32 0.05 ...
Page 12
RECOMMENDED SOLDERING CONDITIONS When soldering this product highly recommended to observe the conditions as shown below. If other soldering processes are used the soldering is performed under different conditions, please make sure to consult with our ...
Page 13
PC1093T: Power mini mold (SOT-89) Process Infrared ray reflow Peak temperature: 235 C or below (Package surface temperature), Reflow time: 30 seconds or less (at 210 C or higher), Maximum number of reflow processes: 2 times. VPS Peak temperature: 215 ...
Page 14
REFERENCE DOCUMENTS Quality Grades on NEC Semiconductor Devices Semiconductor Device Mounting Technology Manual IC Package Manual Semiconductors Selection Guide NEC Semiconductor Device Reliability/Quality Control System -Three Terminal Regulator REMARK OF THE PACKAGE MARK The package marks of the PC1093T and ...
Page 15
PC1093 15 ...
Page 16
The application circuits and their parameters are for reference only and are not intended for use in actual design-ins. No part of this document may be copied or reproduced in any form or by any means without the prior ...