w83977atf Winbond Electronics Corp America, w83977atf Datasheet - Page 140

• Manufacturer Part Number: w83977atf
• Description: Winbond I/o
• Manufacturer: Winbond Electronics Corp America

11.3 Logical Device 1 (Parallel Port)
CR30 (Default 0x01
CR60, CR 61 (Default 0x03, 0x78
CR70 (Default 0x07
CR74 (Default 0x04)
CRF0 (Default 0x3F)
Bit 7 - 1: Reserved.
Bit 0:
These two registers select Parallel Port I/O base address.
[0x100:0xFFC] on 4 byte boundary (EPP not supported) or
[0x100:0xFF8] on 8 byte
address is on
Bit 7 - 4: Reserved.
Bit [3:0]: These bits select IRQ resource for Parallel Port.
Bit 7 - 3: Reserved.
Bit 2 - 0: These bits select DRQ resource for Parallel Port.
Bit 7: PP Interrupt Type:
Bit [6:3]: ECP FIFO Threshold.
Bit 2 - 0 Parallel Port Mode
= 1 Activates the logical device.
= 0 Logical device is inactive.
Not valid when the parallel port is in the printer Mode (100) or the standard & Bi-directional
Mode (000).
= 1
= 0
= 100 Printer Mode (Default)
= 000 Standard and Bi-direction (SPP) mode
= 001 EPP - 1.9 and SPP mode
= 101 EPP - 1.7 and SPP mode
= 010 ECP mode
= 011 ECP and EPP - 1.9 mode
= 111 ECP and EPP - 1.7 mode.
0x00=DMA0
0x01=DMA1
0x02=DMA2
0x03=DMA3
0x04 - 0x07= No DMA active
Pulsed Low, released to high-Z .
IRQ follows nACK when parallel port in EPP Mode or [Printer, SPP, EPP] under ECP.
8 byte
if
if
PNPCSV
PNPCSV
boundary).
boundary
= 0 during POR, default 0x00 otherwise)
= 0 during POR, default 0x00 otherwise)
if
PNPCSV
(all modes supported, EPP is only available when the base
- 140 -
= 0 during POR, default 0x00, 0x00 otherwise)
Publication Release Date:April 1998
W83977ATF
PRELIMINARY
Revision 0.52