tc58dvm92a5ta00 TOSHIBA Semiconductor CORPORATION, tc58dvm92a5ta00 Datasheet - Page 27

• Manufacturer Part Number: tc58dvm92a5ta00
• Manufacturer: TOSHIBA Semiconductor CORPORATION

command
(5)
(6)
(7)
RY
/
WE
RE
CE
BY
Acceptable commands after Serial Input command “80h”
Execution command “10h” or the Reset command “FFh”.
If a command other than “10h” or “FFh” is input, the Program operation is not performed.
Addressing for program operation
the block to MSB (most significant bit) page of the block. Random page address programming is prohibited.
Status Read during a Read operation
mode.
returns to Read mode. In this case, data output starts automatically from address N and address input is
unnecessary.
From the LSB page to MSB page
DATA IN: Data (1)
Once the Serial Input command “80h” has been input, do not input any command other than the Program
Within a block, the pages must be programmed consecutively from the LSB (least significant bit) page of
The device status can be read out by inputting the Status Read command “70h” in Read mode.
Once the device has been set to Status Read mode by a “70h” command, the device will not return to Read
Therefore, a Status Read during a Read operation is prohibited.
However, when the Read command “00h” is inputted during [A], Status mode is reset and the device
80
Command other than
Page 15
Page 31
Page 0
Page 1
Page 2
00
“10h” or “FFh”
Address N
XX
Data (32)
Data register
(16)
(32)
(1)
(2)
(3)
10
Programming cannot be
executed.
Figure 15. page programming within a block
Figure 16.
27
Ex.) Random page program (Prohibition)
DATA IN: Data (1)
command input
Page 15
Page 31
Status Read
Page 0
Page 1
Page 2
For this operation the “FFh” command is needed.
70
Data (32)
Status Read
Data register
TC58DVM92A5TA00
(16)
(32)
(2)
(3)
(1)
00
[A]
Status output
2010-07-13