at90s2323 ATMEL Corporation, at90s2323 Datasheet - Page 5

• Manufacturer Part Number: at90s2323
• Description: 8-bit Microcontroller With 2k Bytes Of In-system Programmable Flash At90s2323 At90ls2323 At90s2343 At90ls2343
• Manufacturer: ATMEL Corporation

Pin Descriptions
AT90S/LS2343
VCC
GND
Port B (PB4..PB0)
RESET
CLOCK
Clock Options
Crystal Oscillator
External Clock
1004D–09/01
Supply voltage pin.
Ground pin.
Port B is a 5-bit bi-directional I/O port with internal pull-up resistors. The Port B output
buffers can sink 20 mA. As inputs, Port B pins that are externally pulled low, will source
current if the pull-up resistors are activated.
Port B also serves the functions of various special features.
Port pins can provide internal pull-up resistors (selected for each bit). The Port B pins
are tri-stated when a reset condition becomes active.
Reset input. An external reset is generated by a low level on the RESET pin. Reset
pulses longer than 50 ns will generate a reset, even if the clock is not running. Shorter
pulses are not guaranteed to generate a reset.
Clock signal input in external clock mode.
The AT90S/LS2323 contains an inverting amplifier that can be configured for use as an
On-chip oscillator, as shown in Figure 3. XTAL1 and XTAL2 are input and output
respectively. Either a quartz crystal or a ceramic resonator may be used. It is recom-
mended that the AT90S/LS2343 be used if an external clock source is used, since this
gives an extra I/O pin.
Figure 3. Oscillator Connection
The AT90S/LS2343 can be clocked by an external clock signal, as shown in Figure 4, or
by the On-chip RC oscillator. This RC oscillator runs at a nominal frequency of 1 MHz
(V
the clock source when programmed (“0”). The AT90S/LS2343 is shipped with this bit
programmed. The AT90S/LS2343 is recommended if an external clock source is used,
because this gives an extra I/O pin.
The AT90S/LS2323 can be clocked by an external clock as well, as shown in Figure 4.
No fuse bit selects the clock source for AT90S/LS2323.
CC
= 5V). A fuse bit (RCEN) in the Flash memory selects the On-chip RC oscillator as
AT90S/LS2323/2343
5