at91sam7l128 ATMEL Corporation, at91sam7l128 Datasheet - Page 35

• Manufacturer Part Number: at91sam7l128
• Description: At91 Arm Thumb-based Microcontroller
• Manufacturer: ATMEL Corporation

9.8
9.9
9.10
9.11
6257AS–ATARM–28-Feb-08
Period Interval Timer
Watchdog Timer
Real-time Clock
PIO Controllers
• Two-pin UART
• Debug Communication Channel Support
• Chip ID Registers
• 20-bit programmable counter plus 12-bit interval counter
• 12-bit key-protected Programmable Counter running on prescaled SLCK
• Provides reset or interrupt signals to the system
• Counter may be stopped while the processor is in debug state or in idle mode
• Two Hundred Year Calendar
• Programmable Periodic Interrupt
• Time, Date and Alarm 32-bit Parallel Load
• Three PIO Controllers.
• Fully programmable through set/clear registers
• Multiplexing of two peripheral functions per I/O line
• For each I/O line (whether assigned to a peripheral or used as general-purpose I/O)
• Synchronous output, provides Set and Clear of several I/O lines in a single write
– One set of Chip ID Registers
– One Interface providing ICE Access Prevention
– USART-compatible User Interface
– Programmable Baud Rate Generator
– Parity, Framing and Overrun Error
– Automatic Echo, Local Loopback and Remote Loopback Channel Modes
– Offers visibility of COMMRX and COMMTX signals from the ARM Processor
– Identification of the device revision, sizes of the embedded memories, set of
– Chip ID is 0x2733 0740 (VERSION 0) for AT91SAM7L128
– Chip ID is 0x2733 0540 (VERSION 0) for AT91SAM7L64
– PIO A controls 26 I/O lines
– PIO B controls 24 I/O lines
– PIO C controls 30 I/O lines
– Input change interrupt
– Half a clock period glitch filter
– Multi-drive option enables driving in open drain
– Programmable pull-up on each I/O line
– Pin data status register, supplies visibility of the level on the pin at any time
peripherals
AT91SAM7L128/64 Preliminary
35